1. November 27, 2015 Energy Conversion and Conservation Notes

2. Which of the following is a measure of the ability to do work? 1. Power 2. Energy 3. Photosynthesis 4. Joules

3. I.) Energy Conversion A) Energy Conversion 1) Energy can be converted from one form to another. 2) Can take place in a series of steps (Ex: striking a match)

4. B) Conservation of Energy 1) The law of conservation of energy states that energy cannot be created or destroyed. (Energy lost = Energy gained) 2) The amount of energy in the beginning must be same amount at the end. a) Example: Riding a bike 1) When you stop pedaling, the bike will eventually stop. Where does the KE go? Frictional forces act on the bike and turn KE into thermal energy

5. C) Energy Conversions 1) Most common conversion is between PE and KE 2) The gravitational PE of an object is converted to the KE of motion as object falls. (Ex: Avalanche)

6. 3) Energy conversions in Pendulums a) KE and PE undergo constant conversion in a pendulum PE is greatest KE = 0 KE is greatest PE = 0 PE is greatest KE = 0

7. Mechanical vs Nonmechanical Energy (write somewhere on your notes- no blanks!) 1. Mechanical Energy- Energy you can “see” * If something has mechanical energy you can see it move (or you would see it move if it only has potential energy)

8. Non-mechanical Energy- energy you cannot “see” Exs- Energy between atoms in a molecule apples give energy when eat them * Non-mechanical energy can be heat energy, light energy (electromagnetic), chemical energy, or nuclear energy. *Once again, you CANNOT SEE non- mechanical energy

9. 4) Calculations -Mechanical Energy = sum of the KE + PE in the components of a mechanical system -Conservation of Mech. Energy: (KE + PE) beginning = (KE + PE) end

10. D) Energy and Mass E = mc 2 1) Einstein’s equation, E=mc 2, says that energy and mass are equivalent and can be converted into each other.

11. II.) Transfer of Thermal Energy A) Conduction: the transfer of energy through direct contact of a material 1) This occurs within a material or between materials that are touching 2) Conduction in gases is slower than in liquids and solids because the particles collide less often in a gas

12. 3) Thermal conductor: transfer of heat energy through a material a) Examples: -Wire rack in hot oven - Tile floor 4) Thermal Insulator: material that is a poor conductor of heat and therefore reduces energy transfer a) Examples: -Wooden spoon - Air - Styrofoam

13. B) Convection: the movement of matter due to differences in density that are caused by temperature variations 1) Particles can transfer thermal energy from hot to cold area 2) Example: Oven -Temp is higher at bottom of the oven - Air at bottom heats up & is then less dense -HOT air RISES - The air that was at the top, cools off & is then more dense -COLD air SINKS

14. 3) Convection current: the vertical movement of air currents due to temperature variation a) Convection currents are important in many natural cycles, such as ocean currents, weather systems, and movements of hot rock in Earth’s interior.

15. C) Radiation: the energy that is transferred as electromagnetic waves, such as visible light & infrared waves 1) Examples: - Sun - Standing by grill & feel the heat - Heat lamp in restaurant

16. Which of the following does a flying Frisbee have the most of? 1. Mechanical potential energy 2. Non-mechanical potential energy 3. Mechanical kinetic energy 4. Non-mechanical kinetic energy

17. Which of the following best describes the motion of the atoms in a cup of hot chocolate? 1. Mechanical potential energy 2. Non-mechanical potential energy 3. Mechanical kinetic energy 4. Non-mechanical kinetic energy

18. Which of the following best describes a wound up clock spring? 1. Mechanical potential energy 2. Non-mechanical potential energy 3. Mechanical kinetic energy 4. Non-mechanical kinetic energy

19. Which of the following best describes a clock spring unwinding? 1. Mechanical potential energy 2. Non-mechanical potential energy 3. Mechanical kinetic energy 4. Non-mechanical kinetic energy

20. Which of the following best describes a skateboarder sitting at the top of a hill? 1. Mechanical potential energy 2. Non-mechanical potential energy 3. Mechanical kinetic energy 4. Non-mechanical kinetic energy

21. Which of the following best describes the energy within the bonds between the atoms in a bowl of cereal? 1. Mechanical potential energy 2. Non-mechanical potential energy 3. Mechanical kinetic energy 4. Non-mechanical kinetic energy

22. Why does a dropped tennis ball not return to its original position? 1. Energy is lost 2. Nonmechanical energy is converted to mechanical energy 3. Mechanical energy is converted to nonmechanical energy 4. There is not enough potential energy

23. A boulder has 600 J of PE. Ignoring air resistance, approximately how much KE does it have right before it hits the ground?