Presentation is loading. Please wait.

Presentation is loading. Please wait.

19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL News –Market survey is close to the final state PS requirements for whole box Bricks specification.

Similar presentations


Presentation on theme: "19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL News –Market survey is close to the final state PS requirements for whole box Bricks specification."— Presentation transcript:

1 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL News –Market survey is close to the final state PS requirements for whole box Bricks specification also added –Radiation conditions changed - new simulations –New design started

2 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL Detailed finger simulations for TID [Gy/10y] ELMB position

3 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL Radiation situation in the fingers changed –new simulations shows easiest way to build the supply –ELMB level for TID is >33Gy ( survived ~80Gy) ability to use it finally inside LV box precise detail simulations done - confirming results LV box shouldn’t be too dependent on ELMB

4 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL Samples of LT brick obtained –basic measurements done –50W load –ripple without load = 15mVpp –with full load ( 50W) = ~ 100mVpp ( no output filter ! )

5 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL New power supply system project in preparation –Specification –Total efficiency computing ( cable requirements included ) –Open questions specified –Cost estimations not yet ready

6 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL Power overview - conditions : Uin = 65V, wire cross section 2mm^2, cable length 250m

7 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL total input power of system will be ~200kW with total efficiency 42% or better 1% of efficiency is ~1.5kW of total power 1V of Uin is ~ 400 - 800W of total power Double the voltage means sharing one cable by 2 LV boxes - cable savings

8 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL

9 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL New design –new schematics prepared –initial radiation tests in preparation - TCC2 May ‘02 isolated amplifier for feedback & measurements original brick new designed brick

10 19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL Conclusion –ELMB is possible to use inside finger –project propagates slower but continues –first radiation tests in preparation


Download ppt "19/2/2002Ivan Hruska EP/ATE LV power supply for TILECAL News –Market survey is close to the final state PS requirements for whole box Bricks specification."

Similar presentations


Ads by Google