1. 1 Nuclear Weapons and Radiological Terrorism 98.101.201 Professor: Thomas M. Regan Pinanski 108

2. 2 Nuclear Weapons Effects  “Nuclear detonations are the most devastating of the weapons of mass destruction. To make this point one need only recall the pictures from Hiroshima or the international furor over the accidental but enormous radiation release from the Chernobyl power plant. The contamination from Chernobyl was significantly larger than would have been expected from a nuclear detonation of about 20 kT at ground level, but was comparable in extent to what might result from a “small” nuclear war in which a dozen or so weapons of nominal yield were exploded at altitudes intended to maximize blast damage. A nuclear detonation creates a severe environment including blast, thermal pulse, neutrons, x- and gamma-rays, radiation, electromagnetic pulse (EMP), and ionization of the upper atmosphere. Depending upon the environment in which the nuclear de- vice is detonated, blast effects are manifested as ground shock, water shock, “blueout,” cratering, and large amounts of dust and radioactive fallout. All pose problems for the survival of friendly systems and can lead to the destruction or neutralization of hostile assets. “ http://www.fas.org/nuke/intro/nuke/effects.htm

3. 3  The energy of a nuclear explosion is transferred to the surrounding medium in three distinct forms: blast; thermal radiation; and nuclear radiation. The distribution of energy among these three forms will depend on the yield of the weapon, the location of the burst, and the characteristics of the environment. For a low altitude atmospheric detonation of a moderate sized weapon in the kiloton range, the energy is distributed roughly as follows:  50% as blast;  35% as thermal radiation; made up of a wide range of the electromagnetic spectrum, including infrared, visible, and ultraviolet light and some soft x-ray emitted at the time of the explosion; and  15% as nuclear radiation; including 5% as initial ionizing radiation consisting chiefly of neutrons and gamma rays emitted within the first minute after detonation, and 10% as residual nuclear radiation. Residual nuclear radiation is the hazard in fallout. Considerable variation from this distribution will occur with changes in yield or location of the detonation http://www.fas.org/nuke/intro/nuke/effects.htm

4. 4  Because of the tremendous amounts of energy liberated per unit mass in a nuclear detonation, temperatures of several tens of million degrees centigrade develop in the immediate area of the detonation. This is in marked contrast to the few thousand degrees of a conventional explosion. At these very high temperatures the nonfissioned parts of the nuclear weapon are vaporized. The atoms do not release the energy as kinetic energy but release it in the form of large amounts of electromagnetic radiation. In an atmospheric detonation, this electromagnetic radiation, consisting chiefly of soft x-ray, is absorbed within a few meters of the point of detonation by the surrounding atmosphere, heating it to extremely high temperatures and forming a brilliantly hot sphere of air and gaseous weapon residues, the so-called fireball. Immediately upon formation, the fireball begins to grow rapidly and rise like a hot air balloon. Within a millisecond after detonation, the diameter of the fireball from a 1 megaton (Mt) air burst is 150 m. This increases to a maximum of 2200 m within 10 seconds, at which time the fireball is also rising at the rate of 100 m/sec. The initial rapid expansion of the fireball severely compresses the surrounding atmosphere, producing a powerful blast wave. http://www.fas.org/nuke/intro/nuke/effects.htm

5. 5  As it expands toward its maximum diameter, the fireball cools, and after about a minute its temperature has decreased to such an extent that it no longer emits significant amounts of thermal radiation. The combination of the upward movement and the cooling of the fireball gives rise to the formation of the characteristic mushroom-shaped cloud. As the fireball cools, the vaporized materials in it condense to form a cloud of solid particles. Following an air burst, condensed droplets of water give it a typical white cloudlike appearance. In the case of a surface burst, this cloud will also contain large quantities of dirt and other debris which are vaporized when the fireball touches the earth's surface or are sucked up by the strong updrafts afterwards, giving the cloud a dirty brown appearance. The dirt and debris become contaminated with the radioisotopes generated by the explosion or activated by neutron radiation and fall to earth as fallout.  The relative effects of blast, heat, and nuclear radiation will largely be determined by the altitude at which the weapon is detonated. Nuclear explosions are generally classified as air bursts, surface bursts, subsurface bursts, or high altitude bursts. http://www.fas.org/nuke/intro/nuke/effects.htm

6. 6  Air Bursts. An air burst is an explosion in which a weapon is detonated in air at an altitude below 30 km but at sufficient height that the fireball does not contact the surface of the earth. After such a burst, blast may cause considerable damage and injury. The altitude of an air burst can be varied to obtain maximum blast effects, maximum thermal effects, desired radiation effects, or a balanced combination of these effects. Burns to exposed skin may be produced over many square kilometers and eye injuries over a still larger area. Initial nuclear radiation will be a significant hazard with smaller weapons, but the fallout hazard can be ignored as there is essentially no local fallout from an air burst. The fission products are generally dispersed over a large area of the globe unless there is local rainfall resulting in localized fallout. In the vicinity of ground zero, there may be a small area of neutron- induced activity which could be hazardous to troops required to pass through the area. Tactically, air bursts are the most likely to be used against ground forces. http://www.fas.org/nuke/intro/nuke/effects.htm

7. 7  Surface Burst. A surface burst is an explosion in which a weapon is detonated on or slightly above the surface of the earth so that the fireball actually touches the land or water surface. Under these conditions, the area affected by blast, thermal radiation, and initial nuclear radiation will be less extensive than for an air burst of similar yield, except in the region of ground zero where destruction is concentrated. In contrast with air bursts, local fallout can be a hazard over a much larger downwind area than that which is affected by blast and thermal radiation.  Subsurface Burst. A subsurface burst is an explosion in which the point of the detonation is beneath the surface of land or water. Cratering will generally result from an underground burst, just as for a surface burst. If the burst does not penetrate the surface, the only other hazard will be from ground or water shock. If the burst is shallow enough to penetrate the surface, blast, thermal, and initial nuclear radiation effects will be present, but will be less than for a surface burst of comparable yield. Local fallout will be very heavy if penetration occurs.  High Altitude Burst. A high altitude burst is one in which the weapon is exploded at such an altitude (above 30 km) that initial soft x-rays generated by the detonation dissipate energy as heat in a much larger volume of air molecules. There the fireball is much larger and expands much more rapidly. The ionizing radiation from the high altitude burst can travel for hundreds of miles before being absorbed. Significant ionization of the upper atmosphere (ionosphere) can occur. Severe disruption in communications can occur following high altitude bursts. They also lead to generation of an intense electromagnetic pulse (EMP) which can significantly degrade performance of or destroy sophisticated electronic equipment. There are no known biological effects of EMP; however, indirect effects may result from failure of critical medical equipment.  http://www.fas.org/nuke/intro/nuke/effects.htm

8. 8  Although some nuclear weapons effects (NWE) such as blast and cratering have analogs in the effects of conventional weapons, many NWE are unique to nuclear use. In addition, blast and other “common” weapons effects are likely to be much more powerful in the nuclear case than in the realm of conventional weapons. NWE are so severe that combinations of two or more simultaneously (as in a real event) may not add linearly, complicating the design and construction of physical simulators or the writing and validation of computer simulation codes.  Although thermal radiation, EMP, and ionizing radiation from a nuclear blast are all damage producing, at yields below about a megaton the blast and shock produced by a nuclear weapon are the predominant means of damaging a target. For some targets, such as underground bunkers and missile silos, blast and shock are virtually the only effective destructive mechanisms.  The intensity of thermal radiation decreases only as the inverse square of the distance from a nuclear detonation, while blast, shock, and prompt ionizing radiation effects decrease more rapidly. Thus, high- yield weapons are primarily incendiary weapons, able to start fires and do other thermal damage at distances well beyond the radius at which they can topple buildings or overturn armored vehicles. http://www.fas.org/nuke/intro/nuke/effects.htm

9. 9  Nuclear effects on electromagnetic signal propagation, which affects command, control, communications, computers, and intelligence (C 4 I), are of concern to countries expected to use nuclear weapons, particularly those which intend to explode a weapon at great altitudes or those which expect to have to defend against such a nuclear attack. C3I technology is primarily affected by high-altitude nuclear effects that could interrupt satellite-to-satellite communications, satellite-to-aircraft links, or satellite- to-ground links. Most nations will hope that signals from Global Positioning System (GPS) satellites and ground-based differential GPS transmitters will be usable shortly after a nuclear explosion, as well as traditional communications channels which must be protected.  The electromagnetic pulse generated by the detonation of a single nuclear weapon at high altitudes can be a threat to military systems located as much as a thousand miles away. HEMP can disable communications systems and even power grids at enormous distances from the burst. This type of threat could be used by a third world country that has the capability to launch a rocket carrying a high-yield device (about 1 megaton or more) a few hundred kilometers into the upper atmosphere and a few thousand kilometers from its own territory (to avoid damaging its own systems). http://www.fas.org/nuke/intro/nuke/effects.htm

10. 10 Impact of a Dirty Bomb or Radiological Dispersion Device (RDD) The extent of local contamination would depend on a number of factors, including the size of the explosive, the amount and type of radioactive material used, the means of dispersal, and weather conditions. Those closest to the RDD would be the most likely to sustain injuries due to the explosion. As radioactive material spreads, it becomes less concentrated and less harmful. Prompt detection of the type of radioactive material used will greatly assist local authorities in advising the community on protective measures, such as sheltering in place, or quickly leaving the immediate area. Radiation can be readily detected with equipment already carried by many emergency responders. Subsequent decontamination of the affected area may involve considerable time and expense. http://www.nrc.gov/reading-rm/doc-collections/fact-sheets/dirty-bombs-bg.html

11. 11 Immediate health effects from exposure to the low radiation levels expected from an RDD would likely be minimal. The effects of radiation exposure would be determined by:  the amount of radiation absorbed by the body.  the type of radiation (gamma, beta, or alpha).  the distance from the radiation to an individual.  the means of exposure–external or internal (absorbed by the skin, inhaled, or ingested)  the length of time exposed. The health effects of radiation tend to be directly proportional to radiation dose. In other words, the higher the radiation dose, the higher risk of injury.  http://www.nrc.gov/reading-rm/doc-collections/fact-sheets/dirty-bombs-bg.html

12. 12 Radiation Threat A radiation threat or "Dirty Bomb" is the use of common explosives to spread radioactive materials. It is not a nuclear blast. The force of the explosion and radioactive contamination will be more localized. In order to limit the amount of radiation you are exposed to, think about shielding, distance and time. Shielding: If you have a thick shield between yourself and the radioactive materials more of the radiation will be absorbed by the thick shield, and you will be exposed to less.

13. 13 Distance: The farther away you are from the radiation the lower your exposure. Time: Minimizing time spent exposed will also reduce your risk.

14. 14 Sources of Radioactive Material Radioactive materials are routinely used at hospitals, research facilities, industrial and construction sites. These radioactive materials are used for such purposes as diagnosing and treating illnesses, sterilizing equipment, and inspecting welding seams. The Nuclear Regulatory Commission together with 33 “Agreement” States, which also regulate radioactive material, administer over 21,000 licenses of such materials. The vast majority of these materials are not useful as an RDD. http://www.nrc.gov/reading-rm/doc-collections/fact-sheets/dirty-bombs-bg.html

15. 15 Control of Radioactive Material NRC and State regulations require owners licensed to use or store radioactive material to secure it from theft and unauthorized access. These measures have been greatly strengthened since the attacks of September 11, 2001. Licensees must promptly report lost or stolen high-risk radioactive material. Local authorities also assist in making a determined effort to find and retrieve such sources. Most reports of lost or stolen material involve small or short-lived radioactive sources not useful for an RDD. Past experience suggests there has not been a pattern of collecting such sources for the purpose of assembling an RDD. It is important to note that the radioactivity of the combined total of all unrecovered sources over the past 5 years (when corrected for radioactive decay) would not reach the threshold for one high-risk radioactive source. Unfortunately, the same cannot be said world- wide. The U.S. Government is working to strengthen controls on high-risk radioactive sources both at home and abroad. http://www.nrc.gov/reading-rm/doc-collections/fact-sheets/dirty-bombs-bg.html

16. 16 Risk of Cancer Just because a person is near a radioactive source for a short time or gets a small amount of radioactive dust on himself or herself does not mean he or she will get cancer. Any additional risk will likely be extremely small. Doctors specializing in radiation health effects will be able to assess the risks and suggest mitigating medical treatment, once the radioactive source and exposure levels have been determined. There are some medical treatments available that help cleanse the body of certain radioactive materials. Prussian blue has been proven effective for ingestion of cesium-137 (a radioactive isotope). In addition, potassium iodide (KI) can be used to protect against thyroid cancer caused by iodine- 131 (radioactive iodine). However, KI, which is available as a “over the counter” pill, offers no protection to other parts of the body or against other radioactive isotopes. Medical professionals are best qualified to determine how to best treat symptoms. “http://www.nrc.gov/reading-rm/doc-collections/fact-sheets/dirty-bombs-bg.html”