1. Matt Waldersen T.J. Strzelecki Rick Schuman Krishna Jharjaria

2.  The proposed project will be a mobile brain- computer interface.  Various computer applications will be presented to the user on a head mounted display system.  The user will be able to navigate between different applications presented on the heads up display through eye gestures detected by an electrooculogram (EOG).  The user will be able to select different applications by increasing their level of concentration measured by an electroencephalogram (EEG).

3. 1) An ability to encode/decode data packets from a NeuroSky EEG. 2) An ability for a user to select applications based on signals from a NueroSky EEG. 3) An ability for a user to navigate between different applications on a display using EOG signals. 4) An ability for the system to interactively train the user to effectively operate the device. 5) An ability to display a live video stream from an external camera module, and integrate applications into the video system.

5.  Processor  Speeds around 1.0 GHz  Utilizes Multithreading, Graphics Optimization  Plenty of Memory  2 GB System Memory  512 MB RAM  Needs at least 8 GPIO pins  High Res Display  No more than 12 Volt Supply  USB out for head-mounted camera  Head-mounted, Mobile, Lightweight  Low Power

6. Intel D2550  1.86 GHz  1M Cache  4 GB max RAM  8 GPIO  8 USB  VGA  1 lb. & 17cm x 17cm  12 V supply Raspberry Pi  0.8 Ghz  256 MB RAM  8 GPIO  2 USB  86mm x 54mm  VGA/HDMI  45 g weight  5 V supply

8.  Signal Processing abilities  Digital Communication  Optimized for C compiler  Resources and reference material  Processing speed  Price

9. DSPIC33EP512MU10 (PIC)  Has USB capabilities  Extensive DSP Library with built in FFT function  4-UART; 4-SPI; 2-I2C  Optimized for C compiler  Large online community  ~53K of RAM DSP56857 (FREESCALE)  Team is familiar with CodeWarrior IDE  120 MIPS  Built in voltage regulator  0-UART; 1-SPI; 0-I2C  Low Power Consumption  24K of RAM

10.  DSP Library allows us to further filter a very sensitive EOG signal.  FFT function will allow us to decompose “raw EEG” signal at 512 Hz instead of headset values which refresh at 1 Hz.  Optimization for C compiler will allow greater simplicity in implementing k-nearest neighbor algorithm for EOG signal classification.  Will be able to communicate with the EOG, the EEG, the FPGA and the single board computer.  Large online community and online documentation will aid in troubleshooting process

12.  Large area to implement Artificial Neural Network  Number of I/O pins needed  Resources and reference material  Built in functionality  Price

13.  Calculated a need of around 12,700 slices. Which equates to about 24,000 logic blocks, based on ANN’s previously made on FPGA’s  Need approximately 20 I/O pins (most FPGA have many more than needed)  Low power, and low cost  Built in functionality to help with development of algorithm  Level of difficulty in designing

14.  Xilinx FPGA (Spartan-6)  Library for floating point arithmetic  Built in 18 bit multipliers  Documented ANN on Xilinx FPGA’s  Abundant reference material on designing and programming  Cheaper than Cyclone  1.14V – 1.26V  More than enough I/O pins  Altera FPGA (Cyclone-II)  Prior knowledge of Altera FPGA’s and Altera software from 437  1.15 V – 1.25 V  More expensive than Spartan  More than enough I/O pins  Unable to find documented successful ANN on Altera devices