1. Senior Project – Electrical Engineering- 2009 Biofeedback Training System for Improved Athletic Performance Matt Statton Advisor – Professor Helen Hanson Abstract: The goal of this project is to produce a biofeedback training system that leads to improved athletic training. Electrical signals produced by muscles when they contract, measured by an electromyograph, are used as an indicator of muscle fatigue. The measured signals are processed using a microcontroller, which analyzes the signals and provides a feedback response to the user when the amplitude gets below a certain threshold. In the end, a biofeedback training system was produced that can help people of all ages and fitness levels maximize their benefits from exercise, reach their goals faster, and improve their health. Electromyograph: A MAX666CPA voltage regulator was used to regulate voltage from a 9V battery to 5V to power the operational amplifiers. An LT1494 operational amplifier, with gain A = 1, was used to create a virtual ground of V CC /2 = 2.5 V. An INA106 differential amplifier, with internal gain A = 10, was used to amplify the differential input from two surface electrodes placed on the proximal and distal portions of the muscle. External resistors were used to increase the gain to A = 110. The electromyograph was created using an LPKF ProtoMat C20S circuit board plotter from a schematic made in EagleCAD. All parts were soldered into the board created by the circuit board plotter. The inputs were connected to electrode leadwires, and the output was connected to the 8051 microcontroller for processing. Design Requirements: Measure electrical signals from muscles Use electrodes to measure electrical signals Amplify signal so it can be analyzed Analyze signal to determine level of muscle fatigue Analog-to-digital conversion of signal from muscle Measure maximum and relative maximum amplitude peaks of signal Determine threshold at which muscle fatigue occurs Compare relative maximum to absolute maximum of signal to determine level of muscle fatigue Provide feedback response to user when muscle fatigue occurs Signal Processing: The electromyogram was analyzed using a Silicon Labs C8051F020 microcontroller. After analog-to-digital conversion using the on-board 12-bit analog-to-digital converter, the microcontroller was programmed to measure the average amplitude of the signal during the first repetition. A running average of the following repetitions was compared to the initial average, and a feedback response was provided to the user when the running average reached a threshold of muscle fatigue based on the initial average. Results: The electromyograph measured the electrical activity of the muscles. However, the microcontroller has not yet been able to consistently measure muscle fatigue based on the amplified electromyogram data. Further work is being done to enable the microcontroller to more accurately measure the level of muscle fatigue of the user. Acknowledgments: Professor Hanson Professor Hedrick Ben Bunes Internal Education Fund Figure 1: EagleCAD schematic designed based on circuit diagram from http://instruct1.cit.cornell.edu/courses/ee476/FinalProject s/s2005/bsm24_ajg47/website/website/index.html Figure 3: Front of electromyograph circuit Figure 4: Back of electromyograph circuit Figure 5: Flow chart of electromyograph signal analysis program Figure 6: Measured Electromyogram signal displaying fully contracted, minimally contracted, and resting biceps muscle Figure 2: EagleCAD board file created from schematic