1. 1 2008. 01 AVL USER GUIDE (GSM) Automatic Vehicle Locator Manual Korea 위치정보통신 www.sos007.co.kr TEL: +82-2-333-2505 FAX: +82-2-333-5885 E-mail: pos0987@naver.compos0987@naver.com Mobile:+82-10-7396-6669

2. 2 ComponentsSpecificationsRemark CPU / Solution ARM 7TDMI, MediaTek Solution MEMORY ROM( Flash memory) 16Mbyte, SDRAM 4Mbyte SMART GPS SiRFstarIII GSC3f/LPx (Active antenna available) - Low power consumption, High performance - Position Accuracy : < 2.5m, <2.0m(SBAS) -TTFF : < 1 sec(Hot Start), < 35 sec(Warm/Cold Start) GSM Modem GSM Quad-band(850/900/1800/1900 MHz), GPRS (Class 12, included TCP/IP) Internal battery Available ( Optiona1) Interface 10 Pin I/O - Included Main Power, 1 Serial Port, 1 Emergency Button,1 engine restart prevention. 1 Audio Port ( Mic/Speaker, Optional) Power Supply 12~30V DC Others Material : Aluminum Reverse voltage prevention diode, over-voltage prevention component.  Vehicle Control Unit AVL (GSM/GPRS) 1-1) Product Introduction 1. Product Introduction

3. 3 IndexFunctionRemark LBS Function 1. Enter a restricted area alarm function - If the vehicle enter a restricted area, report to center 2. Immediate location tracking function - If it received the requiring locations at once, report location information to center 3. Report last stop( engine stop) location to center - If the vehicle’s engine stop, report location and engine stop information to center 4. Updating server ( control center ) information - The device is updated server information( address, etc.) by SMS command 5. Report current setting information to center - The device report device setting values( server address, cycle time, etc) to center 6. Report self-test results to center - The device report result of device’s self-test to center 7. Emergency button - If it occurred emergency situation, report to center immediately 8. Detect vehicle engine start - If vehicle start engine, report to center 9. Prohibit vehicle engine start - If vehicle set prohibit restart engine by control center, Driver can not start engine 10. Block-box function - Store tracking location information in included memory 11. Detect cut off GPS antenna function -If someone remove a GPS antenna, report to center. Optional Function 1. Include Li-ion battery( Optional 400mAh battery) -If someone remove a vehicle battery, report to center using included battery 2. Intercept audio in car function. - it can Intercept audio by center. (Optional microphone ) 1-2) Product Detailed specification – LBS Functions 1. Product Introduction

4. 4 Linked to the GPS Antenna Linked to the GSM Antenna Linked to the Main Connector GPS Signal LED GSM Signal LED Power Signal LED Plug SIMCARD Front side Back Side 1-1) Product Function switch-a Linked to Mic/Spearker 2. Product Function

5. 5 Pin NumDefineI/O TypeMark 1B+InputVehicle battery + ( 10 ~ 30V) 2IGNInput Vehicle ignition signal sensing port Device power on when this signal is high 3 Emergency Switch InputEmergency Switch Input 4Uart TxOutputSerial interface TX (RS232) - Optional 5Ground Vehicle Battery Ground (common ground) - Optional 6Ground Vehicle Battery Ground 7Aux Output-01OutputAuxiliary Output Port - Optional 8ST_ControlOutputImmobilizer, Re-start prevention function 9Uart RxInputSerial interface Rx (RS232) - Optional 10Out_poweroutput 12V / 5V (factory setup) (Max 1A@5V) - Optional 5 5 4 4 3 3 2 2 1 1 10 9 9 8 8 7 7 6 6  Main Connector Pin Define 2-2) Product Function switch-b LED Color Define Power LED (RED) 1. LED Off: Power Off 2. LED On: Power On 3. LED Blink at intervals of 0.5Sec : Main battery (B+) power line is disconnected Modem LED (Green) Green LED indicates the status of GSM/GPRS modem 1. LED On: Normal operation 2. LED Blink at intervals of 1 Sec: Network search 3. LED Blink at intervals of 0.5 Sec : Limited or No service state GPS LED (Yellow) Yellow LED indicates the status of GPS 1. LED On: Satellites found and location fixed, 2. LED Blink at intervals of 1 Sec : Invalid GPS data, position not fixed 3. LED Blink at intervals of 0.5 Sec: GPS wire disconnection 4. LED Off: GPS Module Power Off  LED Function Define PowerGSMGPS  LED Indicator  Main Connector 2. Product Function

6. 6 5 5 4 4 3 3 2 2 1 1 10 9 9 8 8 7 7 6 6 3-1) Product Installation – Main Cable a. Main Cable Connection 3. Product Installation Pin NumDefineColorI/O TypeMark 1B+RedInputVehicle battery + ( 10 ~ 30V) 2IGNYellowInput Vehicle ignition signal sensing port Device power on when this signal is high Ex). Connect to Battery of Vehicle or. Connect to ignition signal of Vehicle 3Emergency SwitchBlueInputEmergency Switch Input 4 5GroundBlockGroundVehicle Battery Ground (common ground) - Optional 6GroundWhiteGroundVehicle Battery Ground 7 8ST_ControlGreenOutputImmobilizer, Re-start prevention function 9 10

7. 7 3-1) Product Installation – Main Cable b. Main Cable Connect to Vehicle 3. Product Installation AVL Car Battery RED White Yellow Blue Black Connect to Relay Emergency Button GSM Antenna GPS Antenna Green Connect to Ignition Line (ACC / Start) It will be power ON the device when the Yellow line be supplied power(12V) Test or Always System power On

8. 8 3-2) Product Installation– Antenna GSM Antenna GPS Antenna 3. Product Installation

9. 9 3-3) Product Installation– SIMCARD Push-Push Type SIM Card Socket 3. Product Installation

10. 10 OnOff Back Side Battery power SW - This switch must be on for the device operation. 3-4) Product Installation– Internal battery On 3. Product Installation

11. 11 1) Product Block Diagram 4. Product Diagram GSM RF GPS Module (SRF III) GSM Main Processor Memory (Flash/Sdram) GSM Quad Band Antenna GPS Active Antenna Uart/Reset /Antenna Detector Power Block (Input to 5V) From Vehicle Battery 12~24V GSM Power Block Multi Port Power Supplier From Vehicle Ignition Signal Battery Slide SW GPS Debug Port GSM Debug Port GPS D/L Slide SW Emergency Button Photo Coupler Photo Coupler Cut Restart to Vehicle Detector Low Voltage Audio Port

12. 12 1) Product Function – Board Picture 5. Product Function Debug Port Battery Connector GPS D/L SW  : Normal Operation  : GPS F/W Download Power Block GSM Block

13. 13 1) Product H/W Detailed specification Index Descriptions Form FactorBlok-Box Type, AVL (Automatic Vehicle Location) System BandQuad Band GSM 850,900,1800,1900, GPS GPSSiRF Star III Dimension12.6 x 90.0 x 21.2 mm ( W x L x H ) AntennaDual Internal (Active GPS / Bar type GSM ) WeightAbout g((Include standard battery) Speaker/Mic3 Pol Interface port O.S Memory128 / 32 ( FLASH / SDRAM) DataTCP/IP, GPRS Class-12, Circuit-switched Data SMSMT/MO Battery490 mAh -Optional Interface10Pin Main Connector, 3-Pol Audio Port Emergency buttonProvide external Emergency button ( Cable Type) LBS FeatureOver the Air Terminal (AVL) Control : - SMS, TCP/IP Auto DetectAuto detect functions : Low Battery, Cut Battery, Cut GPS Ant. 3 LED IndicatorStates indicator of GPS, GSM, Power  General Specification Index Descriptions Storage Temperature-40 C to +85 C Operation Temperature -30 C to +65 C Operating Humidityup to 80%  Environment Specification  GPS Specification Index Descriptions Solution SirfstarIII GSC3f/LPx 50MHz ARM7TDMI processor plus 1Mbit SRAM / 4Mbit flash Position Accuracy Normal < 2.5m SBAS < 2.0m TTFF Time To First Fix - Hot Start : < 1 sec - Ward/Cold Start : < 35 sec Sensitivity Acquisition -142 dBm Tracking -159 dBm 3 LED IndicatorStates indicator of GPS, GSM, Power  Power Consumption Index Descriptions Consumptions for mode Idle mode < 3mA GPS Off, GSM standby mode Normal mode 100 ~ 250mA GPS + GSM Rx/Tx Operation Max Operation 350mA Internal Battery ( 490mAh Battery) - Standby time : 160 hours GPS Off, GSM standby mode - Operation Time : 2.5 ~ 4.5 Hours Continual tracking mode 6. Product H/W Specification