1. King Saud University College engineering Chemical department Air-Cooled heat Exchanger Name: Mohammed Othman Al-zahrani ID:426104592 Dr. Malek

2. INTRODUCTION : Many industrial facilities are required to meet stringent noise requirements. These requirements are imposed to protect workers ’ hearing and/or to meet community ordinances. The facility designer must pay careful attention to the noise level of all industrial equipment, including air-cooled heat exchangers. Measurements for community noise requirements are made at the plant boundary or nearest residence in the far field of the heat exchanger. The far field is defined as the region where there is a linear relationship between the sound pressure level measured and the distance from the noise source.

3. Why use an air-cooled heat exchanger? Air-cooled heat exchangers are generally used where a process system generates heat which must be removed, but for which there is no local use. A good example is the radiator in your car. The engine components must be cooled to keep them from overheating due to friction and the combustion process. The excess heat is carried away by the water/glycol coolant mixture. A small amount of the excess heat may be used by the car's radiator to heat the interior. Most of the heat must be dissipated somehow. One of the simplest ways is to use the ambient air. Air-cooled heat exchangers (often simply called air-coolers) do not require any cooling water from a cooling tower. They are usually used when the outlet temperature is more than about 20 deg. F above the maximum expected ambient air temperature. They can be used with closer approach temperatures, but often become expensive compared to a combination of a cooling tower and a water-cooled exchanger

4. Air Cooled Heat Exchangers Carbon Steel & Stainless Steel Tube bundles assembled for shop run test Air Cooled Heat Exchanger installed in the Kerosene Recovery Unit at Hazira, India

5. Materials of Construction:- 1) Carbon steel with or without NACE requirement and/or HIC testing. 2) Chromium molybdenum (chrome-moly) alloy steel. 3) Stainless steel alloys. 4) Duplex stainless steel alloys. 5) Incolloy material

6. Operation : Fine control of process outlet temperature is achieved by the individual or combination of the following methods of control. 1) Auto variation of fan blade angle. 2) Auto variation of louver blade angle. 3) Variable speed drive system for fan speed control

7. Finned Tube Details FE Tube XE Tube L Tube K Tube G-Fin Tube FE Tube

8. Welded Header Screw – Bolted Header with Cover Studded Header with Cover

9. Plug- Type Header

10. Reference : 1) process heat transfer -G.F Hewitt -G.L Shires -T.R.Bott 2)Rules of Thumb -Carl.B 3) heat Exchanger

11. The end