Presentation is loading. Please wait.

Presentation is loading. Please wait.

Adam Parry Mark Curtis Sam Meek Santosh Shah

Similar presentations


Presentation on theme: "Adam Parry Mark Curtis Sam Meek Santosh Shah"— Presentation transcript:

1 Adam Parry Mark Curtis Sam Meek Santosh Shah
Microwave Optics Adam Parry Mark Curtis Sam Meek Santosh Shah Acknowledgements: Fred, Geoff, Lise and Phil Junior Lab 2002

2 History of Microwave Optics
WW2 in England Sir John Randall and Dr. H. A. Boot developed magnetron Produced microwaves Used in radar detection Percy Spencer tested the magnetron at Raytheon Noticed that it melted his candy bar Also tested with popcorn Designed metal box to contain microwaves Radar Range First home model - $1295

3 How to Make Microwaves Magnetron Oldest, still used in microwave ovens
Accelerates charges in a magnetic field Klystron Smaller and lighter than Magnetron Creates oscillations by bunching electrons Gunn Diode Solid State Microwave Emitter Drives a cavity using negative resistance

4 Equipment Used receiver transmitter

5 Intensity vs. Distance Shows that the intensity is related to the inverse square of the distance between the transmitter and the receiver

6 Reflection M S qI qR Angle of incidence equals angle of reflection

7 Measuring Wavelengths of Standing Waves
Two methods were used A) Transmitter and probe B) Transmitter and receiver Our data Method A: Initial probe pos: 46.12cm Traversed 10 antinodes Final probe pos: 32.02cm  = 2*( )/10  = 2.82cm Method B: Initial T pos: 20cm Initial R pos: 68.15cm Traversed 10 minima Final R pos: 53.7cm  = 2.89cm

8 Refraction Through a Prism
Used wax lens to collimate beam No prism – max = 179o Empty prism – max = 177o Empty prism absorbs only small amount Prism w/ pellets – max = 173o Measured angles of prism w/ protractor q1 = 22 +/- 1o q2 = 28 +/- 2o Used these to determine n for pellets n = /- 0.1

9

10 Polarization Microwaves used are vertically polarized
Intensity depends on angle of receiver Vertical and horizontal slats block parallel components of electric field

11 Single Slit Interference
Used 7 cm and 13 cm slit widths This equation assumes that we are near the Fraunhofer (far-field) limit

12 Single Slit Diffraction – 7cm
Not in the Fraunhofer limit, so actual minima are a few degrees off from expected minima

13 Single Slit Diffraction – 13cm

14 Double Slit Diffraction
Diffraction pattern due to the interference of waves from a double slit Intensity decreases with distance y Minima occur at d sinθ = mλ Maxima occur at d sinθ = (m + .5) λ

15 Double Slit Diffraction
Mirror Extension S M

16 Lloyd’s Mirror Interferometer – One portion of wave travels in one path, the other in a different path Reflector reflects part of the wave, the other part is transmitted straight through.

17 Lloyd’s Mirror D1= 50 cm H1=7.5 cm H2= 13.6 cm = 2.52 cm D1= 45 cm
Condition for Maximum: Trial 1 Trial 2 D1= 50 cm H1=7.5 cm H2= 13.6 cm = 2.52 cm D1= 45 cm H1=6.5 cm H2= 12.3 cm = 2.36 cm

18 Fabry-Perot Interferometer
Incident light on a pair of partial reflectors Electromagnetic waves in phase if: In Pasco experiment, alpha(incident angle) was 0.

19 Fabry-Perot Interferometer
d1 = distance between reflectors for max reading d1 = 31cm d2 = distance between reflectors after 10 minima traversed d2 = 45.5cm lambda = 2*(d2 – d1)/10 = 2.9cm Repeated the process d1 = 39cm d2 = 25cm lambda = 2.8cm

20 Michelson Interferometer
Studies interference between two split beams that are brought back together.

21 Michelson Interferometer
Constructive Interference occurs when:

22 Michelson Interferometer
Split a single wave into two parts Brought back together to create interference pattern A,B – reflectors C – partial reflector Path 1: through C – reflects off A back to C – Receiver Path 2: Reflects off C to B – through C – Receiver Same basic idea as Fabry-Perot X1 = A pos for max reading = 46.5cm X2 = A pos after moving away from PR 10 minima = 32.5cm Same equation for lambda is used Lambda = 2.8cm S M reflectors

23 Brewster’s Angle Angle at which wave incident upon dielectric medium is completely transmitted Two Cases Transverse Electric Transverse Magnetic Equipment Setup

24 Transverse Electric Case at
TE Case S polarization Electric Field transverse to boundary Using Maxwell’s Equations (1 = 2 =1) Transverse Electric Case at oblique incidence NO BREWSTER’S ANGLE

25 Transverse Magnetic Case at
TM Case Electric Field Parallel to Boundary Using Maxwell’s Equations (1 = 2 =1) P polarization Transverse Magnetic Case at oblique incidence

26 Brewster’s Angle Plotting reflection and transmission(for reasonable n1 and n2)

27 Brewster’s Angle (our results)
Setting the T and R for vertical polarization, we found the maximum reflection for several angles of incident. We then did the same for the horizontal polarization and plotted I vs. theta We were unable to detect Brewster’s Angle in our experiment.

28 Bragg Diffraction Study of Interference patterns of microwave transmissions in a crystal Two Experiments Pasco ( d = 0.4 cm, λ = 2.85 cm) Unilab (d = 4 cm, λ = 2.85 cm). Condition for constructive interference

29 Bragg Diffraction (Pasco)

30 Bragg Diffraction(Unilab)
Maxima Obtained Maxima Predicted Wax lenses were used to collimate the beam

31 Frustrated Total Internal Reflection
Two prisms filled with oil Air in between Study of transmittance with prism separation Presence of second prism “disturbs” total internal reflection. Transmitter Detector

32 Frustrated Total Internal Reflection

33 Optical Activity Analogue
E-field induces current in springs Current is rotated by the curve of the springs E-field reemitted at a different polarization Red block (right-handed springs) rotates polarization –25o Black block (left-handed springs) rotates polarization 25o

34 References www.joecartoon.com www.mathworld.wolfram.com


Download ppt "Adam Parry Mark Curtis Sam Meek Santosh Shah"

Similar presentations


Ads by Google