2. Energy resources: Oil

3. Oil (petroleum) and natural gas Petroleum =Latin petra (rock) + oleum (oil ) Necessary conditions for formation: Biological productivity (biomass) of the surface water must be able to generate a settling “rain” of dead organisms The bottom waters must have low oxygen to prevent decay and scavengers

4. Formation process Remains of microscopic marine organisms (phytoplankton, zooplankton and larvae of larger animals) get deposited and buried under marine sediments on the sea floor (DEPOSITIONAL BASINS) Burial depth is at least 500 m

5. Because of burial, pressure and temperature increases Ideal temperature for converting organic matter to crude oil is 50-100ºC Chemical reactions take place SLOWLY to transform organic materials into hydrocarbon molecules present in oil

6. http://mpgpetroleum.com/fundamentals.html

7. For formation and accumulation of an exploitable oil deposit, there must be: –A SOURCE ROCK for oil generation –A RESERVOIR ROCK for storage –A CAPROCK to confine it –A GEOLOGIC STRUCTURE to “TRAP” the oil

8. SOURCE ROCKS are: –Sedimentary rocks, mostly shales and limestones –Fine grained (<1/16 mm in diameter) –Almost all source rocks are dark colored (high organic content) The increased pressure and temperature in the source rock “squeeze” the oil out of the source rock and make it migrate to a lower pressure RESERVOIR ROCK

9. Reservoir rocks are usually sandstones, limestones or fractured shales (porous and permeable) Why do reservoir rocks need to be both porous and permeable? A CAPROCK keeps the oil from escaping to the surface Are caprocks porous or permeable or both?

10. Geological structures that “traps” Oil and gas ANTICLINE TRAP: Convex-upward fold in a layered rock FAULT TRAP: When rock layers break (by FAULTING), impermeable layers may lie next to permeable layers and “trap” the oil.

12. STRATIGRAPHIC TRAP: When a porous and permeable STRATUM (layer) changes laterally into an impermeable layer Example: ancient coral reefs covered by shale Oil fields in the Middle East are of this type.

13. SALT DOMES: Rising “fingers” of impermeable salt traps oil against it as well as in the overlying dome Example: “Old Spindletop”, Beaumont, TX

14. OIL PRODUCTION Modern-day oil prospectors use sound waves to locate oil. In one technique, (1) a signal is sent into the rock by a vibrator truck (2) the reflected waves are received by geophones, and, (3) the data is transmitted to a laboratory truck. Animation courtesy of Elf Aquitaine. http://fossil.energy.gov/education/energylessons/oil/oil2.html

15. The first well drilled is called “WILDCAT WELL”. Chance of a wildcat well being successful is 1 in 50 (less favorable than the odds in roulette) Initially a successful oil well may not need pumping as oil under high reservoir pressure “gush” to the surface (PRIMARY RECOVERY) High reservoir pressure may develop from water pressure or dissolved gas.

16. Eventually the oil flow under natural pressure falls off and pumping becomes necessary. Up to 75% of the total oil may still remain in the trap even after pumping SECONDARY RECOVERY methods are applied at this point Require INJECTION WELLS for injecting fluids and EXTRACTION WELLS for oil removal

17. SECONDARY RECOVERY methods: WATERFLOODING –Pump water through injection wells into the reservoir to wash some of the oil out –Can generate only 10-15% of the remaining oil (leaves 65-70% of the total oil in the reservoir) FRACKING (more on that later on)

18. ENHANCED RECOVERY methods: (most of these methods are still in the experimental stage) 1.THERMAL –Injection of steam to make the oil less viscous and make it flow –Injection of air in the well to set fire to the oil to produce gases and heat to increase the flow http://fossil.energy.gov/education/energylessons/oil/oil4.html

19. 2.CHEMICAL –Water mixed with large molecule compounds (called SURFACTANTS) to wash the oil –POLYMERS to break down large oil molecules in smaller parts –CO 2 to generate pressure to push the oil up –Fluids that mix with oil (miscible) are used to remove “stuck” oil from the reservoir 3.Using MICROBES (biological)

20. IMPACTS OF FOSSIL FUELS Impacts of oil drilling/recovery Disruption of the land and/or ecosystemsDisruption of the land and/or ecosystems http://www.explorenorth.com/library/photosofweek/caribou_no_impact.html

21. SubsidenceSubsidence Water pollution due to leakage from pipelines, oil byproducts (brine) and from recovery fluidsWater pollution due to leakage from pipelines, oil byproducts (brine) and from recovery fluids http://energy.usgs.gov/ak-cns-images.html Oil pipeline on central North Slope coastal plain. Photo by Dave Houseknecht (USGS).

22. Oil seepage and oil spills under water for offshore drilling rigsOil seepage and oil spills under water for offshore drilling rigs Release of toxic drilling mudRelease of toxic drilling mud http://www.rigjobs.co.uk/oil/semisub.shtml

23. Air pollutionAir pollution Aesthetic degradationAesthetic degradation http://www.carlmaples.com/Sunset_Rig5.html