1. Electrical Wiring Circuit Board Project

2. STEP 1 - Identify all Parts of the Project Saw Drill Driver w/ bits Drill w/bits (not pictured) #2 Phillips Screwdriver Straight Screwdriver Pliers Tape and/or Ruler/Square Hammer Pencil 2 x 4 Douglass Fir Board 2 x 4 Metal Enclosure 2 x 4 Plastic Enclosure 4” Octagon Enclosure #8 x 1-1/4” Screws Non-Metalic Cable Clamp

3. STEP 2 – Review Safety Rules & Gear Power Tool Safety Hand Tool Safety General Shop Safety & Working in Groups Safety Glasses Coveralls Appropriate shoes Have Safety Gear on Hand and WEAR IT!

4. STEP 3 – Cut 2 x 4 to Length

5. STEP 4 – Install Metal Enclosure

6. STEP 5 – Install 4” Octagon Enclosure 1.Mark the center of the 2 x 4 (@12”), and draw a line 2.Notice the screws that stick through the bottom of the box. These screws are for securing the Romex cable that goes into this box. 3.Use a drill to make holes in the 2 x 4 to accommodate these screws. 4.Mount the 4” Octagon Enclosure with the 4 screws.

7. STEP 6 – Install Plastic Enclosure 1.Measure and mark a line 1” from the right end of the board. 2.Position the plastic box so that the box sticks over the edge of the board by ½”. 3.In a house wiring situation, this will allow for ½” sheet rock to be installed around the box. 1.Nail enclosure in place using the nails provided. 2.Be careful not to drive nails in to farr as the box may break (it is made of plastic).

8. STEP 7 – Install Cable Clamp 1.Remove ½” knockout from the metal enclosure. 2.Be sure to remove the right one. 3.Install Cable Clamp with the retaining nut inside the box.

9. STEP 7 – Install Cable Clamp 1.Use pliers to tighten the retaining nut on the clamp. You should not be able to loosen the clamp by hand once it is installed. 2.The clamp should be horizontal when tight.

10. STEP 8 – Finished Product