1. WEEK 7: WEB-ASSISTED OBJECT DETECTION ALEJANDRO TORROELLA & AMIR R. ZAMIR

2. GEOMETRY METHOD RESULTS Made threshold extremely low for each class Needed to make sure that the true positives were detected Sifted through the many bounding boxes by using the GIS arrangement to get rid of obvious spatially incorrect detections. Ex: A trash can was detected on the left side of the image when there aren’t any according to the GIS data. Got rid of bounding boxes that were smaller than and larger than a certain percentage of the image. Had to manually set GIS data for each image, crude methods of obtaining them manually didn’t give good results.

3. GEOMETRY METHOD RESULTS: IMAGE 1 GIS fusion with three classes. Classes were fire hydrants, street lights, and traffic lights. Got 1/4 street lights The other street lights didn’t come up in the detectors at all. Too small in the image, or were too occluded Got 2/3 traffic signals Got 0/1 fire hydrants The detector didn’t get the true positive in the image

4. Before GIS fusion

5. After GIS fusion

6. GEOMETRY METHOD RESULTS: IMAGE 2 GIS fusion with two classes. Classes were trash cans and street lights. Got 2/3 street lights The last street light didn’t come up in the detectors at all. Too small in the image and/or threshold not low enough Got ½ trash cans The other trash can didn’t come up in the detectors at all. Too small in the image and/or threshold not low enough

7. Before GIS fusion

8. After GIS fusion

9. GEOMETRY METHOD RESULTS: IMAGE 3 GIS fusion with two classes. Classes were traffic signals and street lights. Got 2/3 street lights Got 3/6 traffic signals The other traffic signals were so close together than the detector was drown off.

10. Before GIS fusion

11. After GIS fusion

12. GEOMETRY METHOD: CONCLUSIONS Sifting the bounding boxes using the GIS data resulted in better results compared to sifting them by their size relative to the image. Lowering threshold helped a lot too. Detectors aren’t getting all the true positives which makes the GIS fusion fail Can’t improve what’s already failed. Need to implement some sort of vertical constraint to further improve results Had to manually set GIS data to get the best results.

13. GOALS FOR NEXT WEEK Look into more automatic methods for obtaining Field of vision Range of visibility Orientation of the camera Look into some sort of y-direction constraint Look into using early fusion as well as late fusion

14. THANK YOU FIN.