1. SampleName1Name2-- X10 Y1525 Z3-2 Rot0°45° Roll0°0° | Pitch0° SampleName1Name2-- X10 Y1525 Z3-2 Rot0°45° Fine rot0.2°0.1° XES Mode Sample environment: Room temperature XAS Mode Sample environment: Room temperature The Sample Name entered by user in the top row gives the name (prefix) of the ascii file. “File prefix” field is now removed. Checkboxes are to enable or disable (grey-out) multiple sample positions as appropriate. Maximum of 4. ROOM TEMPERATURE SAMPLE ENVIRONMENT Click on a sample’s column to edit Description for that Sample. If none is selected, Description box indicates this. Could alternatively include a Description field inside table, but it looks untidy. Description: Sample ‘Name2’ Material supplied by PP University. Pellet with BN substrate. Description: (None selected)

2. SampleName1Name2-- Y1525 Fine position 0.1-0.6 Sample position Checkboxes are to enable or disable (grey-out) multiple sample positions as appropriate. Maximum of 3. SetpointTemperature 180 K 270 K 3100 K 430 K Add Setpoint Remove Setpoint CRYOSTAT SAMPLE ENVIRONMENT – basic options (always visible) Arbitrary number of set points can be added. Loop over sample first, then over temperature Loop over temperature first, then over sample Temperature Setpoints “Fine position” is OFFSET from centre of sample. Ramping options to be integrated at a later date The Sample Name entered by user in the top row gives the name (prefix) of the ascii file. “File prefix” field is now removed. Greyed-out if there is only one sample or only one temperature setpoint. 0.1 K Tolerance 60 s Wait time

3. Only likely to use these two most of the time. Note that when the control mode is changed, the Lakeshore sets the P, I, D parameters all to zero, so they must be re-applied. Advanced Manual PID Zone control Open Loop Auto-tune PID Control Mode Manual output P I D 30 10 0 0 % Heater range Off 4mW 40mW 400mW 4W 40W Applies additional power on top of that calculated by the PID loop CRYOSTAT SAMPLE ENVIRONMENT – ‘advanced tab’ options We will need to create new scannables for each of these, in addition to some others not shown on the Editor like Heater Output. Suggest to name them like this: ‘lakeshore_heater_output’ ‘lakeshore_control_mode’ ‘lakeshore_heater_range’ ‘lakeshore_p’ etc…