1. Router

2. General Safety Wear your safety glasses at all times Take off all jewelry Do not wear loose clothing Make sure you give yourself a comfortable working space when using the router.

3. General Safety continued Stay on the perimeter of the tables when working with the routers Make all changes and adjustments to the router when it is not plugged in Never let the router bit, that is in the router, touch the table whether the machine is on or off. Never forcefully stop the router bit once the machine is turned off………. especially with your fingers!!!!

4. Components of the Router Wrenches Base Depth Dial Thumbscrew

5. Router bits Roman Ogee/ Ogee Classical Round over Beading Cove Cove with bead Chamfer Laminate trimmer/Flush

6. Router bits Rabbetting Straight

7. Router Set-up When L oosening the bit, make sure the motor is to your L eft When putting a bit in the router, make sure the shaft of the bit is all the way in. When Tight ening the bit make sure the router motor is to your Right. Adjust the depth of cut by turning the dial to raise or lower the base.

8. Router Set-up Tighten the thumbscrew! Clamp the project to the table with wood screw clamps. Plug the router in….. Turn the machine on Make multiple passes! This means a lot of passes! Do not take the full cut off in one pass! The bearing on the router bit will eventually touch your project and follow the edge.

9. Router Set-up When creating an external cut, move the router COUNTERCLOCKWISE When creating an internal cut, move the router CLOCKWISE.

10. Wrenches

11. Base

12. Depth Dial

13. Thumbscrew

14. Roman Ogee/Ogee

15. Classical

16. Roundover

17. Beading

18. Cove

19. Cove with Bead

20. Chamfer

21. Laminate trimmer / Flush bit

22. Rabbetting

23. Straight

24. L oosen …… L eft

25. Bit all the way in

26. Tight…….Right

27. Adjust depth of cut BAD GOOD

28. Tighten the Thumbscrew

29. Clamp the project

30. Plug in – Turn on

31. External cut - COUNTERCLOCKWISE

32. Internal cut - CLOCKWISE