1. Degraded Image Ethan Vicars

2. This is my original image Fresh off the printer

3. I printed out letters I wanted to use Fresh off the printer

4. I taped the two pieces of paper together I also needed a light source for tracing

5. Tracing is complete I used a black sharpie

6. I ripped the tape off It didn’t tear as much as I thought it would

7. I started to cut out the traced letters This was pretty difficult

8. The cutting complete

9. I traced ALL onto a Styrofoam block Again with the black sharpie

10. Then I cut out ALL from the Styrofoam This step was extremely messy

11. Next I glued the two cutouts together The glue had a hard time staying on top of the Styrofoam because it is so porous

12. I glued the image to some construction paper That got me thinking why is it called construction paper

13. I glued the Styrofoam ALL to the construction paper Again with the pores

14. You can hardly tell there is Styrofoam there

15. I lit the image on fire This was a controlled burn

16. I wet a paper towel My dabbing technique was flawless

17. This is where the water soaked in

18. Water damage On top of fire damage

19. This was the final project I really like the way it came out

20. Different Angle

21. BeginningEnd