1. DMX Controller
SB-DN-512DMX

2. Wiring 512ch DMX scene controller DMX bus to other DMX fixtures
to Ethernet hub
512ch DMX scene controller
DMX bus
to other DMX
fixtures
Computer lighting
Moving heads
Moving heads

3. Wiring Diagram Wiring Diagram DMX bus DMX bus
connect to other DMX fixture
DMX status LED
HDL Buspro
10-30VDC
3ch 650mA LED driver

4. 3CH 650mA LED Driver Set the DMX start channel
Special function: mainly for testing whether the device works or not
channel B ON
light G ON
light R ON
lights R&G&B ON
Start channel(range )：
e.g., If you use screw driver to set the start channel as 004, then the rest two channels will be ch5 & ch6, so R channel=4, G channel=5, B channel=6.

5. IP Setting
There is a LCD panel and some keys on this module, you can manually check or change the IP via them. Whenever the IP is changed, the module is needed to be reset. (press the four keys at the same time for several seconds.) e.g., set the IP as , then reset it, after that, change the IP of the laptop as and ping , see if it can be pinged successfully.
4/26/2017

6. Basic Information subnet ID and device ID Device remark
Generally no need to set it if just DMX512/1990
(if use Art-Net or HDL-NET, need to set these parameters.)
Change the ID if needed

7. Area
Current area
Channels of current area

8. Area Remark
Area remark
Save

9. Area Setup Channels waiting to be assigned.
Select an area
Create new area
Channels waiting to be assigned.
Add channels to and delete channels from current area
Channels in current area

10. Channel Channel remark
Effect property - CANCELED
Make sure that Lower limit ≤ Higher limit ≤ Max limit, setting range: 0% - 100%
Mapping relationship between “HDL channel” and “DMX channel”
Channel remark

11. Scene
Select Area
Fill in a range to be involved
Scene remark

12. Scene Setup Useful option when creating a scene.
Running time: the transit time till the scene reaches the preset brightness.
Mix the levels of channels to create scene
save
Useful option when creating a scene.

13. Add Sequence
Add sequence

14. 4/26/2017
Sequence
Current sequence
Steps (scenes) of current sequence

15. Sequence Setup Step (scene) Qty Set running times Set sequence mode
save

16. Sequence Setup 4/26/2017 save Assign a scene to each step
Set running time of each step
save

17. Channel Control use button 1 to control channel 1 of DMX512:
Set 'single on/off' mode, and input the DMX 512 ID(1/104), control type is 'single channel lighting control', parameter1 is for channel number(1-4), paremeter2 is for brightness(0-100).

18. Scene Control use button 2 to control scene 1 of DMX512:
Set 'single on/off' mode, and input the DMX512 ID(1/104), control type is 'scene', parameter1 is for area number, paremeter2 is for scene number.

19. Sequence Control use button 3 to control sequence 1 of DMX512:
Set 'single on/off' mode, and input the DMX512 ID(1/104), control type is 'sequence', parameter1 is for area number, paremeter2 is for sequence number.