1. Human Alive Detection and Locating the Detection Area Using GPS and XBee Student Name USN NO Guide Name H.O.D Name Name Of The College & Dept

2.  CONTENTS 1.Abstract 2.Objectives 3.Block diagram 4.Methodology 5.Advantages & disadvantages 6.Applications 7. Conclusion

3. 1.ABSTRACT: In this paper, a new approach for detecting alive humans in destructed environments using a autonomous robot is proposed. Alive human body detection system proposed a monitoring system using PIR sensors to analyze conditions of human body. The task of identify human being in rescue operations is difficult for the robotic agent but it is simple for the human agent. In order to detect a human body, an autonomous robot must be equipped with a specific set of sensors that provide information about the presence of a person in the environment around. This work describes a autonomous robot for rescue operations. The aim of this article is to present our experience with various sensors designed and developed.

4. 2.OBJECTIVES: Since the main intension of this projects is to design Highly Secured Robotic Control For human alive detection Using MSP430 in order to rescue peoples from dangerous situation order to fulfill this application there are few steps that has been performed.

5. 3.BLOCK DIAGRAM : A block diagram which is shown above is divided into two parts that is transmitter and receiver. The transmitter part is which is in the control room which can be controlled from the remote area using XBee as a communication protocol. The person at the transmitting end controls the robot of the remote areas using key inputs by using password in MSP 430 controller if any person detects alive at the remote area then the sensor detects it and it sends co-ordinates of the location to the control area using XBee.

6. BLOCK DIAGRAM Transmitter

7. Receiver

8. 4. METHODOLOGY: A block diagram which is shown above is divided into two parts that is transmitter and receiver. The transmitter part is which is in the control room which can be controlled from the remote area using XBee as a communication protocol. The person at the transmitting end controls the robot of the remote areas using key inputs by using password in MSP 430 controller if any person detects alive at the remote area then the sensor detects it and it sends co-ordinates of the location to the control area using XBee.

9. 5. ADVANTAGES & DISADVANTAGES: ADVANTAGES: 1.Less cost 2.Less complexity 3.By the using this robot we save the humans and protect the our country

10. DISADVANTAGES: 1.When power off, then the total system is off, so all ways we required battery. 2.It need a person to operate this robot every time

11. 6.APPLICATIONS: 1.In military applications to detect the presence of human being. 2.In Rescue operations where human reach is not possible. 3.In Warfield affected areas, to detect the presence of bomb.

12. 7.CONCLUSION: The goal of this research was to provide a low cost rescue robot for human detection in a disaster environment. Though, the existing Urban Search and Rescue Robots are equipped with various sensors, but the problem with them is the cost. The sensors used in the development of this project are easily available and cost effective.

13. THANK YOU