1. QUAD POD TRANSFORMABLE VEHICLE Supervisor: Dr. Samer Mayaleh Ala’ Lahham Basmah AbdAlrahman Leena Talalweh Department of Electrical Engineering Quadpod Transform Vehicle

2. The Outline  Introduction  Electrical Parts  Demonstration of Quadpod and Vehicle modes Quadpod Transform Vehicle

3. Introduction  The transformable vehicle with two wheels and four legs  The vehicle that can detect obstacles to transformed into the Quadpod mode  The vehicle fully controlled by a remote controller  The miniature model for the new type of vehicle for unpaved, bumpy roads

4. 9V Battery Voltage 9V Max Capacity 550mAh

5. Arduino Mega Operating Voltage5V Input Voltage (recommended)7-12V Input Voltage (limits)6-20V Digital I/O Pins 54 (of which 15 provide PW M output) Analog Input Pins16 DC Current per I/O Pin40 mA DC Current for 3.3V Pin50 mA Flash Memory 128 KB of which 4 KB used by bootloader SRAM8 KB EEPROM4 KB Clock Speed16 MHz Quadpod Transform Vehicle

6. Servo Motor  Operation of the Motors The degree changes by pulse lengths Quadpod Transform Vehicle

7. IR receiver and Remote Controller Quadpod Transform Vehicle It has 9 different commands Operates from 2.5-5.5V 5mA supply current

8. Code for IR Quadpod Transform Vehicle Decoded keys at the start of the code

9. Code Quadpod Transform Vehicle  Contain two major codes  Vehicle mode  Quadpod mode  Int “tr” was used to determine which code will be activated.  Command “key = getIRKey()” is used to obtain signal from IR receiver.