Presentation is loading. Please wait.

Presentation is loading. Please wait.

Silicon Module Tests The modules are tested in the production labs. HIP is is participating in the rod quality tests at CERN. The plan of HIP CMS is to.

Similar presentations


Presentation on theme: "Silicon Module Tests The modules are tested in the production labs. HIP is is participating in the rod quality tests at CERN. The plan of HIP CMS is to."— Presentation transcript:

1 Silicon Module Tests The modules are tested in the production labs. HIP is is participating in the rod quality tests at CERN. The plan of HIP CMS is to build a minitracker facility in Helsinki (Kumpula detector lab) to study system aspects and tracking with cosmic rays and a source, when production of rods is advanced enough. As a first step a single module test setup has been built by HIP CMS at CERN. It is being used in collaboration with the CERN TOB group. BUT: The minitracker project of HIP is on hold due to lack of funds.

2 R&D on Radiation Hard Detectors Novel types of silicon structures being processed at HUT Microelectronics Center (1) Electric measurements in the Kumpula Clean Room Irradiations at Jyväskylä Accelerator Center (2001 – 2002) (2) Measurements at the H2 beam at CERN with the HIP SiBT 1 2

3 Detector tests The full size Cz processed detectors have been successfully tested in summer 2002 at the H2 test beam at CERN with the HIP SiBT. They show comparable performance to the conventional FZ detectors The irradiated Cz detectors have been measured again at the H2 beam with SiBT in 2003.

4 R&D collaboration partners Good collaboration with national and international partners: Microelectronics Centre, Helsinki University of Technology Laboratory of Machine Design, Helsinki University of Technology Accelerator Laboratory, University of Jyvaskylä CERN RD50 and RDF39 collaborating institutes –Brookhaven National Laboratory (USA) –University of Hamburg (Germany) –Ioffe Physico-Technical Institute (Russia )

5 SAB 3.6.2002Eija Tuominen5 RPC Link Activities Link Board for the RPC muon trigger and data transmission has been designed as a Helsinki-Warsaw project. The prototype is ready and tested in a beam at CERN (1). Design for Board Integration to CMS is being completed (2). Link Board production (2100 boards) will take place in 2004 in Finland under supervision of the University of Lappeenranta. 1 2

6 2. HIP CMS Software and Physics CMS Core software and computing GEANT4 development Software alignment of the tracker Physics simulation and preparation for reconstruction and physics analysis

7 HIP CMS Software and Physics GEANT4 simulation tools Nuclear cascade models implemented and compared with data p(597 MeV) + Pb   + (  =135 o ) + X

8 HIP CMS Software and Physics Software alignment of the pixel tracker new algorithms are being developed 144+240 sensors

9 CMS trigger and computing Level-1 maximum trigger rate100 kHz Average event size1 Mbyte Builder network 1 Terabit/s Event filter computing power≈5 10 6 MIPS Event flow control≈10 6 Mssg/s No. Readout systems≈512 No. Filter systems≈512 x n System dead time≈ % HLT output Level-1 Event rate Tracking and vertexing Electron validation CMS Core software and computing GEANT4 simulation tools Software alignment of the tracker RPC trigger link

10 High Level Trigger and reconstruction studies Multilevel trigger system: Level-1 (40 MHz → 100 kHz)High Level Triggers (100 kHz → 100 Hz) Our contributions: electron identification & background rejection Pixel match:Electron isolation: Photon reconstruction

11 HIP CMS Software and Physics The HIP CMS group has participated in the development of the CMS detector concept since the beginning in 1991. It has contributed to the design of CMS by studying its discovery potential by physics and detector simulation, mainly for Higgs search.

12 Useful channels: H/A , H   Tan  measured from event rates At large tan  :  ~tan 2  *x  tan  /tan  =1/2*sqrt((N s +N b )/N s 2 + (  L/L) 2 + (  x/x) 2 ) Theor. error  x/x ~ 20% (Spira,Willenbrock) Luminosity error  L/L ~ 5% At ( m A =200GeV,tan  =20) H/A  :  tan  /tan  ~ 11%  tan  /tan  < 15% if Higgs boson detected with 5  signal Estimate of tan  measurement precision at large tan 

13

14

15 Computing hardware activities at Kumpula  1.4 TB Linux fileserver has been built for CMS Monte Carlo data storage  Linux cluster being assembled: 32 nodes + frontend 2U box per node 66 CPUs in total 2,13 GHz Athlon MP2600+ 1 GB memory per node 100 Mb/s LAN 2*80 GB hard disk/node To be used in the CMS Data Challenge 2004

16 HIP CMS and Grid  HIP is a Member of the EU DataGrid and NorduGrid projects  NorduGrid test platform has been operational in Kumpula since September 2002  Connecting the fileserver to NorduGrid as a storage element is in progress

17 Finnish CMS: Personnel Senior Scientist (9) Grad students (9) Engineers (1) (1)rs (1) Post-docs (2) A.HeikkinenHIP T. LampénGRASPANP P. LuukkaHIP T. MäenpääHIP J. NystenGRASPANP T.PalviainenLUT D. UngaroHIP M. VoutilainenHIP L. WendlandHIP P.AarnioHUT S. CzellarHIP V. KarimäkiHIP R. KinnunenHIP K. Lassila-PeriniHIP T. LindénHIP J. TuominiemiHIP E. TuominenHIP T.TuuvaLUT J. HärkönenSA S. Lehti SA H. Katajisto HIP

18 HIP CMS Programme Funding (MEuro)

19 HIP CMS Programme ”CORE” Funds (kEuro)


Download ppt "Silicon Module Tests The modules are tested in the production labs. HIP is is participating in the rod quality tests at CERN. The plan of HIP CMS is to."

Similar presentations


Ads by Google