1. Denial of Service (DoS)

2. Overview Introduction Background Benchmarks and Metrics Requirements Summary of Methods Conclusion Vijay C Uyyuru Prateek Arora Terry Griffin

3. What is denial of service attack? When a denial of service (DoS) attack occurs, a computer or a network user is unable to access resources like e-mail and the Internet. An attack can be directed at an operating system or at the network.

4. Denial of Service DoS Bad guy Victim Compromised host Third parties

5. What is distributed denial of service? A distributed denial of service (DDoS) attack is accomplished by using the Internet to break into computers and using them to attack a network. Hundreds or thousands of computer systems across the Internet can be turned into “zombies” and used to attack another system or website.

6. Distributed Denial of Service DDoS Bad guy Master agent Victim (s) Slave agents (zombies, bots) Third parties Owned host

7. Brief history and trends DoS attacks started at around early ’90s. At the first stage they were quite "primitive", involving only one attacker exploiting maximum bandwidth from the victim, denying others the ability to be served. This was done mainly by using simple methods of ping floods, SYN floods and UDP floods. These attacks had to be "manually" synchronized by a lot of attackers in order to cause an effective damage.

8. Brief history and trends The shift to automating this synchronization, coordination and generating a parallel massive attack became public in 1997, with the release of the first publicly available DDoS attacks tool, Trinoo. In the following years, few more tools were published – TFN (tribe flood network), TFN2K, and Stacheldraht ("Barbed wire" in German).

9. Massive attack on public sites

10. The subject came to public awareness only after a massive attack on public sites on February 2000. During a period of three days the sites of Yahoo.com, amazon.com, buy.com, cnn.com & eBay.com were under attack. Analysts estimated that Yahoo! Lost $500,000 in e-commerce and advertising revenue when it was knocked offline for three hours.

11. Interesting Facts It turned out that about fifty computers at Stanford University, and also computers at the University of California at Santa Barbara, were amongst the zombie computers sending pings in these DoS attacks. A study during a period of three weeks in February 2001 showed that there were about 4000 DoS attacks each week. Most DoS attacks are neither publicized in the news media nor prosecuted in courts.

12. How does an attack work? One way to attack a company’s network or website is to flood its systems with information. Web and e-mail servers can only handle a finite amount of traffic and an attacker overloads the targeted system with packets of data.

13. Impact Denial-of service attacks can essentially disable the computer or the network. Depending on the nature of the enterprise, this can disable your organization. Some denial-of-service attacks can be executed with limited resources against a large, sophisticated site. This type of attack is sometimes called an “asymmetric attack”. For example, an attacker with an old PC and a slow modem may be able to disable much faster and more sophisticated machines or network.

14. Attack classification DoS attacks exploit the asymmetric nature of certain types of network traffic. One attack method seeks to cause the target to use more resources processing traffic than the attacker does sending the traffic. Another method is to control multiple attackers. Therefore DoS attacks can be classified into three categories 1.Bandwidth/Throughput Attacks 2.Protocol Attacks 3.Software Vulnerability Attacks

15. Bandwidth/Throughput Attacks Ping Flood Attack (ICMP echo) SYN Flood Attack (DoS attack) DDoS Attack (Distributed SYN Flood) UDP Flood Attacks

16. Ping Flood Attack An attempt by an attacker on a high bandwidth connection to saturate a network with ICMP echo request packets in order to slow or stop legitimate traffic going through the network.

17. SYN Flood Attack

18. DDoS Attack The idea behind this attack is focusing Internet connection bandwidth of many machines upon one or a few machines. This way it is possible to use a large array of smaller (or “weaker”) widely distributed computers to create the big flood effect.

19. UDP Flood Attacks UDP protocol is a connectionless unreliable protocol which doesn't require session negotiation between client and server application. UDP provides easy to use interface for producing large quantity of packets. A common attack which exploits UDP simply floods the network with UDP packets destined to a victim's host. Due to the relative simplicity of this protocol an attacker can produce large bandwidth capacity with relatively small effort.

20. Protocol Attacks Smurf Attack DNS name server Attack

21. Smurf Attack In this attack, spoofed IP packets containing ICMP Echo-Request with a source address equal to that of the attacked system and a broadcast destination address are sent to the intermediate network. Sending a ICMP Echo Request to a broadcast address triggers all hosts included in the network to respond with an ICMP response packet, thus creating a large mass of packets which are routed to the victim's spoofed address.

22. Smurf Attack (contd.)

23. DNS name server Attack The most common method seen involves an intruder sending a large number of UDP-based DNS requests to a Nameserver using a spoofed source IP address. Any Nameserver response is sent back to the spoofed IP address as the destination. In this scenario, the spoofed IP address represents the victim of the denial of service attack. The Nameserver is an intermediate party in the attack. The true source of the attack is difficult for an intermediate or a victim site to determine due to the use of spoofed source addresses.

24. Software Vulnerability Attacks Land Attack Ping of Death Attack Fragmentation Attack and Teardrop Attack

25. Land Attack In this attack, an attacker sends spoofed TCP SYN packets, with the same source and destination addresses as the victim's host address. In some TCP/IP stack implementations those kinds of packets may cause the victim's host to crash. Any remote user that can send spoofed packets to a host can crash or "hang" that host. Possible solution for this attack is to block IP-spoofed packets. Attacks like those of the Land tool rely on the use of forged packets, that is, packets where the attacker deliberately falsifies the origin address. With the current IP protocol technology, it is impossible to eliminate IP-spoofed packets. However, you can reduce the likelihood of your site's networks being used to initiate forged packets by filtering outgoing packets that have a source address different from that of your internal network.

26. Ping of Death Attack Ping of Death is an attempt by an attacker to crash, reboot or freeze a system by sending an illegal ICMP (over IP) packet to the host under attack. The TCP/IP specification allows for a maximum packet size of up to 65536 octets. In some TCP stack implementation encountering packets of greater size may cause the victim's host to crash.

27. Teardrop Attack A normal packet is sent. A second packet is sent which has a fragmentation offset claiming to be inside the first fragment. This second fragment is too small to even extend outside the first fragment. This may cause an unexpected error condition to occur on the victim host which can cause a buffer overflow and possible system crash on many operating systems. Teardrop attacks target a vulnerability in the way fragmented IP packets are reassembled. Fragmentation is necessary when IP Datagrams are larger than the maximum transmission unit (MTU) of a network segment across which the Datagrams must traverse. In order to successfully reassemble packets at the receiving end, the IP header for each fragment includes an offset to identify the fragment's position in the original un-fragmented packet. In a Teardrop attack, packet fragments are deliberately fabricated with overlapping offset fields causing the host to hang or crash when it tries to reassemble them.

28. How to handle DoS Protecting – Among the aspects of protecting our systems and our business, are looking at network design, discussing our agreement with your ISP, putting detection mechanisms and a response plan in place, and perhaps taking out an insurance policy. Proper preparation is essential for effective detection and reaction. Unfortunately, some sites begin their cycle with detection and reaction, triggering preparation steps after a “lessons learned” experience. Detecting – Our ability to detect attacks directly affects our ability to react appropriately and to limit damages. Among the approaches we can take are instituting procedures for analyzing logs and using automated intrusion detection systems. Reacting – Reaction steps, hopefully put in place as part of preparing for an attack, include following our response plan, implementing specific steps based on the type of attack, calling our ISP, enabling backup links, moving content, and more. Technical steps include traffic limiting, blocking, and filtering.

29. Summary Flood AttacksDos Attack Types Logic / Software Attacks

30. Summary Flood Attacks TCP SYN Flood Attack Smurf IP Attack UDP Flood Attack ICMP Flood Attack

31. Summary TCP SYN Flood Attack Graphic: http://www.narizone.it/sezioni/firewall/Immagini/SYN_sequence.gif Taking advantage of the flaw of TCP three-way handshaking behavior, an attacker makes connection requests aimed at the victim server with packets with unreachable source addresses. The server is not able to complete the connection requests and, as a result, the victim wastes all of its network resources. A relatively small flood of bogus packets will tie up memory, CPU, and applications, resulting in shutting down a server.

32. Summary Smurf IP Attack An attacker sends forged ICMP echo packets to broadcast addresses of vulnerable networks. All the systems on these networks reply to the victim with ICMP echo replies. This rapidly exhausts the bandwidth available to the target, effectively denying its services to legitimate users.

33. Summary UDP Flood Attack UDP is a connectionless protocol and it does not require any connection setup procedure to transfer data. A UDP Flood Attack is possible when an attacker sends a UDP packet to a random port on the victim system. When the victim system receives a UDP packet, it will determine what application is waiting on the destination port. When it realizes that there is no application that is waiting on the port, it will generate an ICMP packet of destination unreachable to the forged source address. If enough UDP packets are delivered to ports on victim, the system will go down.

34. Summary ICMP Flood Attack An ICMP flood occurs when ICMP pings overload a system with so many echo requests that the system expends all its resources responding until it can no longer process valid network traffic. icmp

35. Summary Logic / Software Attacks Flood Attacks Dos Attack Types

36. Summary Ping of DeathTeardropLandEcho/Chargen Logic / Software Attacks

37. Summary Ping of Death An attacker sends an ICMP ECHO request packet that is much larger than the maximum IP packet size to victim. Since the received ICMP echo request packet is bigger than the normal IP packet size, the victim cannot reassemble the packets. The OS may be crashed or rebooted as a result. Expected Packet Size Actual Packet Size

38. Summary Teardrop An attacker sends two fragments that cannot be reassembled properly by manipulating the offset value of packet and cause reboot or halt of victim system. Many other variants such as targa, SYNdrop, Boink, Nestea Bonk, TearDrop2 and NewTear are available.

39. Summary Land An attacker sends a forged packet with the same source and destination IP address. The victim system will be confused and crashed or rebooted 198.215.34.56

40. Summary Echo/Chargen The character generator (CharGen) service is designed is primarily used for testing purposes. Remote users/intruders can abuse this service by exhausting system resources. Spoofed network sessions that appear to come from that local system's echo service can be pointed at the CharGen service to form a "loop." This session will cause huge amounts of data to be passed in an endless loop that causes heavy load to the system. When this spoofed session is pointed at a remote system's echo service, this denial of service attack will cause heavy network traffic/overhead that considerably slows your network down.

41. Conclusion / Question What makes DoS attacks possible?

42. Susceptibility to attacks could be alleviated with better Internet Architectures (goal of class). Don’t leave all the decision making to the machines on either end of a connection Provide ‘intelligent’ support along the path ( e.g. No Blind forwarding of packets ) Create “Hardened” networks Conclusion

43. Questions