1. Arc/MIG/TIG Welding Safety Notes

2. 1. PROTECT YOUR SKIN by wearing leather or flame resistant canvas coat and gloves. PROTECT YOUR HEAD AND EYES by wearing an approved welding helmet equipped with a minimum shade 10 lens and protective cover glass. Observers must wear EYE PROTECTION (as above).

3. 2. STUDENTS WEARING CONTACT LENSES MUST NOT USE AN ELECTRIC WELDER or be exposed to its arc.

4. 3. All welding equipment must be in good operating condition. Never use damaged equipment.

5. 4. NEVER STRIKE AN ARC unless you and the onlookers have protective lenses in place.

6. 5. Always place a suitable barrier around the work area to protect others from arc radiation. Use shaded screens (shade 8 minimum) when possible. Be aware of others at all times when welding. Notify others that you are about to weld This is very important if you are not in a protected welding booth.

7. 6. When welding the area must be free of water and your footwear dry.

8. 7. Ensure all connectors are fastened securely.

9. 8. Ensure the ventilation system is turned on and working.

10. 9. Check for flammable substances before beginning to weld.

11. 10. Always clamp ground cable to your work piece. Be aware of any bearings installed on the work piece.

12. 11. Take breaks to help relieve arm fatigue.

13. 12. Always pick up hot pieces using tongs or pliers.

14. 13. All welding equipment must be in good operating condition, never use damaged equipment. Always ensure the teacher is aware of any equipment problems.