1. Fundamentals Of LAN and WAN Chapter 4 powered by DJ

2. Chapter Objectives  Understand what is Ethernet LAN  Identify types of Ethernet LAN  Understand Ethernet addressing  Define broadcast and collision domains  Identify cable types  Explain Ethernet UTP Cabling  Understand basic concepts of WAN At the end of this Chapter you will be able to: powered by DJ

3. Ethernet Networking  Ethernet is a contention media access method that allows all hosts on a network to share the same bandwidth of a link. Ethernet is popular because it’s readily scalable, meaning that it’s comparatively easy to integrate new technologies, such as Fast Ethernet and Gigabit Ethernet, into an existing network infrastructure. It’s also relatively simple to implement in the first place, and with it, troubleshooting is reasonably straightforward. Ethernet uses both Data Link and Physical layer specifications. powered by DJ

4. Some Ethernet Specifications powered by DJ

5. Media Access  Ethernet networking uses Carrier Sense Multiple Access with Collision Detection (CSMA/CD), a protocol that helps devices share the bandwidth evenly without having two devices transmit at the same time on the network medium. CSMA/CD was created to overcome the problem of those collisions that occur when packets are transmitted simultaneously from different nodes.  Basically, the CSMA/CD algorithm can be summarized as follows:  A device that wants to send a frame waits until the LAN is silent—in other words, no frames are currently being sent—before attempting to send an electrical signal.  If a collision still occurs, the devices that caused the collision wait a random amount of time and then try again. powered by DJ

6. Ethernet at the Data Link Layer  Ethernet at the Data Link layer is responsible for Ethernet addressing, commonly referred to as hardware addressing or MAC addressing. Vendor IDAdaptor ID Ethernet Addressing Scheme Ethernet Addressing 24 bits powered by DJ

7. Broadcast Domain & Collision Domain Broadcast Domain  A broadcast domain is a logical division of a computer network in which all nodes can reach each other by broadcast at the data link layer.  In terms of current popular technologies: Any computer connected to the same Ethernet Repeater or Switch is a member of the same broadcast domain. Further, any computer connected to the same set of inter- connected switches/repeaters is a member of the same broadcast domain. powered by DJ

8. Collision Domain  A Collision domain is a logical network Segment where data packets can "collide" with one another for being sent on a shared medium, in particular in the Ethernet networking protocol. This is an Ethernet term used to describe a network scenario wherein one particular device sends a packet on a network segment, forcing every other device on that same segment to pay attention to it.  Collisions decrease network efficiency; if two devices transmit simultaneously, a collision occurs, and both devices must retransmit at a later time. powered by DJ

9. Ethernet at the Physical Layer Ethernet Physical layer Specifications powered by DJ

10.  10Base2 10Mbps, baseband technology, up to 185 meters in length: It is known as thinnet and can support up to 30 workstations on a single segment.  10Base5 10Mbps, baseband technology, up to 500 meters in length It is known as thicknet. It uses a physical and logical bus with AUI connectors. Up to 2,500 meters with repeaters and 1,024 users for all segments. powered by DJ

11.  10BaseT 10Mbps using category 3 UTP wiring Unlike with the 10Base2 and 10Base5 networks, each device must connect into a hub or switch, and you can have only one host per segment or wire Here are the expanded IEEE Ethernet 802.3 standards:  100BaseTX (IEEE 802.3u): EIA/TIA category 5, 6, or 7 UTP two-pair wiring. One user per segment; up to 100 meters long. It uses an RJ45 connector with a physical star topology and a logical bus.  100BaseFX (IEEE 802.3u): Uses fiber cabling 62.5/125-micron multimode fiber. Point-to-point topology; up to 412 meters long. It uses an ST or SC connector, which are media interface connectors. powered by DJ

12. Conti…  1000BaseCX (IEEE 802.3z): Copper twisted-pair called twinax (a balanced coaxial pair) that can only run up to 25 meters.  1000BaseT (IEEE 802.3ab): Category 5, four-pair UTP wiring up to 100 meters long.  1000BaseSX (IEEE 802.3z): MMF using 62.5- and 50-micron core; uses an 850 nanometer laser and can go up to 220 meters with 62.5-micron, 550 meters with 50-micron.  1000BaseLX (IEEE 802.3z): Single-mode fiber that uses a 9-micron core and 1300 nanometer laser and can go from 3 kilometers up to 10 kilometers. powered by DJ

13. Ethernet Cabling Introduction Three types of Ethernet cables are available:  Straight-through cable  Crossover cable  Rolled cable powered by DJ

14. Straight-Through Cable The straight-through cable is used to connect  Host to switch or hub  Router to switch or hub Notice that only pins 1, 2, 3, and 6 are used. Just connect 1 to 1, 2 to 2, 3 to 3, and 6 to 6 Straight-through Ethernet cable powered by DJ

15. Crossover Cable The crossover cable can be used to connect  Switch to switch  Hub to hub  Host to host  Hub to switch  Router direct to host Notice that instead of connecting 1 to 1, 2 to 2, and so on, here we connect pins 1 to 3 and 2 to 6 on each side of the cable. powered by DJ

16. Conti… powered by DJ

17. Rolled Cable  Although rolled cable isn’t used to connect any Ethernet connections together, you can use a rolled Ethernet cable to connect a host to a router console serial communication (com) port. Rolled Ethernet Cable powered by DJ

18. How to Make an Ethernet Cable  Requirements  Bulk Ethernet Cable (RJ-45) Bulk RJ45 Crimpable Connectors powered by DJ

19. Conti…  RJ-45 Crimping tool powered by DJ

20.  Standard, Straight-Through Wiring (Both Ends Are the Same) RJ45 Pin # Wire Color (T568A) Wire Diagram (T568A) 10Base-T Signal 100Base-TX Signal 1White/GreenTransmit+ 2GreenTransmit- 3White/OrangeReceive+ 4BlueUnused 5White/BlueUnused 6OrangeReceive- 7White/BrownUnused 8BrownUnused Standard Straight-through Wiring powered by DJ

21.  Straight-Through Cable Pin out for T568A RJ45 Pin # Wire Color (T568B) Wire Diagram (T568B) 10Base-T Signal 100Base-TX Signal 1White/OrangeTransmit+ 2OrangeTransmit- 3White/GreenReceive+ 4BlueUnused 5White/BlueUnused 6GreenReceive- 7White/BrownUnused 8BrownUnused powered by DJ

22.  Straight-Through Cable Pin out for T568B RJ45 Pin # Wire Color (T568B) Wire Diagram (T568B) 10Base-T Signal 100Base-TX Signal 1White/OrangeTransmit+ 2OrangeTransmit- 3White/GreenReceive+ 4BlueUnused 5White/BlueUnused 6GreenReceive- 7White/BrownUnused 8BrownUnused powered by DJ

23. Basics of WAN  What is WAN? Wide Area Network (WAN) is a Computer network that covers a broad area (i.e., any network whose communications links cross metropolitan, regional, or national boundaries). Or, a network that uses routers and public Communication Links. Conceptual View of Point-to-Point Leased Line powered by DJ

24. The several options available for WAN connectivity are: OptionDescriptionAdvantages Disadvan tages Bandwidth range Sample protocols used Leased line Point-to-Point connection between two computers or Local Area Networks (LANs) Most secure Expensiv e PPPPPP, HDLC, SDLC, HNASHDLC SDLCHNAS Circuit switching A dedicated circuit path is created between end points. Best example is dialup connections dialup Less Expensive Call Setup 28 Kb/s - 144 Kb/s PPPPPP, ISDNISDN powered by DJ

25. Conti.. Packet switching Devices transport packets via a shared single point-to-point or point-to-multipoint link across a carrier internetwork. Variable length packets are transmitted over Permanent Virtual Circuits (PVC) or Switched Virtual Circuits (SVC)PVCSVC Shared media across link X.25X.25 Frame- RelayFrame- Relay powered by DJ

26. Conti.. Cell relay Similar to packet switching, but uses fixed length cells instead of variable length packets. Data is divided into fixed-length cells and then transported across virtual circuits best for simultaneous use of Voice and data OverheadOverhead can be considerable ATM powered by DJ

27. WAN Cabling Standards Serial Cabling Options powered by DJ

28. THANK YOU powered by DJ