1. 1. © Solids Suspension In Stirred Tanks With Pitched Blade Turbines Sharma, RN; Shaikh, AA PERGAMON-ELSEVIER SCIENCE LTD, CHEMICAL ENGINEERING SCIENCE; pp: 2123-2140; Vol: 58 King Fahd University of Petroleum & Minerals http://www.kfupm.edu.sa Summary In view of developing a universal correlation for critical speed of suspension, extensive suspension experiments were conducted with tank scales in the range of 15- 121 cm, D/T from 0.083 to 0.625, using four different sizes of spherical glass beads and employing Pitched Blade Turbines with four and six blades as the impellers. The periphery of the tank bottom was modified to include a permanent fillet in order to eliminate the effect of induced recirculation loop, which account for the formation of peripheral fillets of unsuspended solids. The critical speed of suspension N-c and power P-c were observed to vary independently both with D and T to give two correlations for each of the variables, N-c and P-c; one for the close proximity impeller operation where both N-c and P-c remained invariant with off-bottom impeller clearance and the second for the region where N-c and P-c were affected significantly by the impeller position. The effects of the physical characteristics of the solids were also included in the four correlations so proposed. It was clearly noticed that the correlations were valid up to a critical value of D/T beyond which the trapped particles in the stagnant zone below the impeller needed extra energy to be raked out and suspended, thus breaking the log-linear relationship between N-c (or P-c) and D/T hitherto maintained. Comparisons of the suspension speed and power have been made with open literature. More importantly, the reasons why the earlier studies differed with each other in N-c-predictions have been identified. (C) 2003 Elsevier Science Ltd. All rights reserved. References: ARMENANTE PM, 1998, CAN J CHEM ENG, V76, P413 Copyright: King Fahd University of Petroleum & Minerals; http://www.kfupm.edu.sa

2. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32. 33. 34. 35. 36. © ARMENANTE PM, 1998, CHEM ENG SCI, V53, P1757 BALDI G, 1978, CHEM ENG SCI, V33, P21 BARRESI A, 1987, CHEM ENG SCI, V42, P2949 BOHNET M, 1980, GER CHEM ENG, V3, P57 BOURNE JR, 1974, P 1 EUR C MIX SEP BUURMAN C, 1986, CHEM ENG SCI, V41, P2865 CHAPMAN CM, 1983, CHEM ENG RES DES, V61, P71 CHUDACEK MW, 1982, 4 EUR C MIX, P275 CHUDACEK MW, 1985, CHEM ENG SCI, V40, P385 CHUDACEK MW, 1986, IND ENG CHEM FUND, V25, P391 EINKEL WD, 1977, VERFAHRENSTECHNIK, V11, P90 GATES LE, 1976, CHEM ENG, V83, P144 GRAY DJ, 1987, CHEM ENG COMMUN, V61, P151 GRAY JB, 1986, MIXING THEORY PRACTI, V3, P1 JOSHI JB, 1982, CHEM ENG SCI, V37, P813 KAWASE Y, 1997, IND ENG CHEM RES, V36, P270 KNEULE F, 1967, VERFAHRENSTECHNIK, V1, P531 KOLAR V, 1961, COLLECT CZECH CHEM C, V26, P613 KOTZEK R, 1969, MITT I CHEM, V9, P53 MYERS KJ, 1992, CAN J CHEM ENG, V70, P596 MYERS KJ, 1994, AICHE S SERIES, V90, P186 MYERS KJ, 1994, CAN J CHEM ENG, V72, P745 NAGATA S, 1975, MIXING PRINCIPLES AP NIENOW AW, 1968, CHEM ENGNG SCI, V23, P1453 NIENOW AW, 1985, MIXING PROCESS IND, P364 OLDSHUE JY, 1983, FLUID MIXING TECHNOL, P94 OLDSHUE JY, 1992, AICHE S SER, V88, P72 RAI BN, 1991, THESIS BANARAS HINDU RAO KSM, 1988, AICHE J, V34, P1332 RIEGER F, 1994, CHEM ENG SCI, V49, P2219 SHARMA RN, 1989, ANN AICHE M CHIC UPADHYAY S, 1994, REV CHEM ENG, V10, P4 WEISMAN J, 1960, AICHE J, V6, P419 WONG CW, 1987, CAN J CHEM ENG, V65, P412 ZWIETERING TN, 1958, CHEM ENG SCI, V8, P244 For pre-prints please write to: abstracts@kfupm.edu.sa Copyright: King Fahd University of Petroleum & Minerals; http://www.kfupm.edu.sa