1. While lattice-matched Ga 0.51 In 0.49 P on GaAs has the ideal bandgap for the top converter in triple- junction GaAs-based solar cells, more complex designs will benefit from flexibility in the composition of this alloy. Changes in the gallium/indium ratio are accompanied by lattice- mismatch relative to GaAs substrates, so higher dislocation densities are expected in alternative gallium/indium epitaxial alloys. We report deep level transient spectroscopy (DLTS) and photocapacitance measurements on metamorphic, Zn-doped Ga 0.58 In 0.42 P. The experimental evidence, including thermally-activated non-exponential capture and escape and an augmented optical threshold energy, indicates that hole traps with an occupation-dependent lattice configuration are present in this device. Similar behavior has been linked with Zn-doping in GaAsP, raising the suspicion that zinc may also be involved in the AX-like complex reported here. Defect states with an occupation-dependent lattice configuration in zinc-doped Ga 0.58 In 0.42 P on GaAs T. H. Gfroerer and D. G. Hampton Davidson College, Davidson, NC 28035 M. W. Wanlass National Renewable Energy Laboratory, Golden, CO 80401 5  m p+ (Zn) GaAsP Step Grade Layer and Contact (Zn) GaAs Substrate 2  m p (Zn) GaInP Base 0.01  m n+ (S) GaInP Emitter 0.05  m n+ (S) GaAsP Contact GaInP Interrupt Schematic of the test structure (not to scale). Motivation: Multi-junction solar cellsPhotocapacitance optical cross-section DLTS Capture and Escape Device Structure Experimental Setup N+ P + + + + Depletion Layer - - - + - - - Depletion with bias + + + + - - - - - - - - - - - - - - - - - - - - - - - -- + + DLTS and Photocapacitance Changing lattice configuration model Conclusion and Acknowledgement The authors would like to thank J. J. Carapella for performing the MOVPE growth and processing the devices. Acknowledgment is made to the Davidson Research Initiative, funded by The Duke Endowment, and the donors of the American Chemical Society – Petroleum Research Fund for support of this research. Higher energy photons are absorbed in higher bandgap alloys, reducing the heat loss caused by excess photon energy relative to the gap. Deep level transient spectroscopy (DLTS) and photocapacitance employ transient capacitance measurements on diodes during and/or after the application of a bias pulse to monitor the capture/emission of carriers into/out of defect-related traps. The pulse generator applies reverse and pulse (toward zero) biases to the sample while the capacitance meter reads the resulting change in capacitance as a function of time. For DLTS, we study how dark measurements change with temperature. For photocapacitance, we study how cold measurements change with the energy of illumination from the monochromator. The optical escape threshold energy of 0.70 eV is significantly higher than the thermal escape energy of 0.32 eV, supporting an occupation-dependent lattice configuration model like the one shown below. Defect centers with an occupation-dependent lattice configuration (namely, DX centers) are relatively common in n-type III-V alloys, particularly near bandgap crossover. This report of analogous behavior in p-type material suggests that acceptor complexes (i.e. AX centers) may also form in Zn- doped high-bandgap GaInP and related alloys. If this interpretation is correct, Zn-related AX centers may limit the performance of these alloys in photovoltaic cells. (0.70 eV) (0.32 eV) (0.21 eV) Conventional and stretched exponential fits to the capture transient measured at 143 K, demonstrating the non-exponential response and the suitability of the stretched exponential analysis. Arrhenius plot of the stretched exponential rates (k) used to fit the capture and escape transients. We obtain thermal activation energies of 0.21 eV for capture and 0.32 eV for escape. In the occupation-dependent model, the energy of the system changes as a function of the local configuration of the lattice. This means that lattice vibrations, or phonons, can push the defect level closer to the valence band, but photons, which carry very little momentum, have no effect on the defect level. As a result, the optical escape energy is much larger than the thermal activation energies. The Stretched Exponential: