1. Disk Sander

2. General Safety Wear your safety glasses at all times Take off all jewelry Do not wear loose clothing Make sure you are the only person in the safety zone when operating the disk sander.

3. General Safety continued Keep your material tight against the table Keep your hands away from the disk

4. Components of the Disk Sander Disk Table Miter Gauge

5. Operations of the Disk Sander External Arcs Angles Straight

6. Disk Always use the down stroke OR the right side

7. Table

8. Miter Gauge

9. Sanding External Arcs Sanding external arcs is defined as sanding an arc that is formed where an edge and an end of a piece of material meet at a radius.

10. Sanding Angles Sanding angles is defined as sanding an area of a piece of material that is not 90 degrees to an edge or end.

11. Straight Sanding Straight sanding is defined as sanding an end of a piece of material that needs a 90 degree end to edge sand.

12. Operation Procedure 1 1. Make sure the table is 90 degrees to the disk

13. Operation Procedure 2 2. Turn the machine on and clean the disk with the disk eraser.

14. Operation Procedure 3 Move the project across the table utilizing the whole disk (center to end) for even wear and to prevent burn marks.

15. Set table 90° to the disk