1. P2 NUCLEAR FISSION

2. NUCLEAR FISSION P2H α Rn Po
Radioactive isotopes emit small particles from their nuclei which only change the mass and atomic numbers slightly.
ALPHA 2+ 87
136
137
134
135 85 84 83 86 N P α
222 86 Rn
218 84 Po 4 2 α +
Alpha decay:
Mass - 4,
Atomic - 2
Neutrons - 2, Protons – 2

3. + + - Sr Y β Al Mg β Beta minus (electron) Beta plus (positron)
Beta - decay:
Mass no change,
Atomic +1
Neutrons - 1, Protons +1 90 38 Sr 39 Y + -1 β 24 13 Al 12 Mg + +1 β
Beta + decay:
Mass no change,
Atomic -1
Neutrons +1, Protons -1 41 52 53 50 51 39 38 37 40 N P β־ 15 12 13 10 11 14 N P β+

4. Rather than emitting small particles, nuclear FISSION involves a nucleus SPLITTING into two LARGE FRAGMENTS.
Although some isotopes do fission by themselves, most need to be “induced” to split by absorbing another particle, usually a neutron.
The isotopes most used in nuclear reactors are Uranium-235 and Plutonium-239

5. FISSION OF 235U
Fast neutrons pass through the uranium nucleus, without causing it to split
Fast neutron
235U
Slow neutrons are absorbed by the 235U nucleus, becoming an unstable 236U nucleus which then splits into two smaller nuclei and three FAST neutrons
Slow neutron

6. The nucleus can fission in more than one way
Some
mass
‘missing’
236 92 U
235 1 n +
144 56 Ba + 90 36 Kr 1 n 3
236 92 U
235 1 n +
148 57 La + 85 35 Br 1 n 3
Products
Reactants
The PROUCTS have a mass about 0.088% LESS than the REACTANTS. This ‘missing’ mass or MASS DEFECT is converted into the KINETIC ENERGY of the reactant particles. On a large scale this appears as HEAT.

7. “Missing” mass converted to ENERGY
The amount of energy E produced from the mass defect m is given by Einstein’s famous equation E = mc2
Where c = speed of light (3 x 108 or 300 million m/s).
If 1kg of U-235 atoms ALL split then there would be about 0.88g of mass ‘missing’ which would be converted into 8.19 x 1013 J (82 trillion J), enough to run a 2 bar electric fire for about 1300 years!

8. KE OF NUCLEI RISES RAPIDLY SO RAPID TEMPERATURE RISE
Chain Reaction
If the FAST neutrons produced in the reaction could be slowed down then they could be used to induce further fission in other U-235 atoms.
Graphite (CARBON) MODERATOR Collision with C atoms slows down the fast neutrons
KE OF NUCLEI RISES RAPIDLY SO RAPID TEMPERATURE RISE

9. CRITICAL MASS
To keep a chain reaction going, there must be enough uranium to prevent too many neutrons escaping from the sides. The mass of uranium needed to keep the reaction going is called the CRITICAL MASS.
Too many neutrons escape without colliding with U atoms, reaction slows down
Neutrons have much higher chance of colliding with U atoms so reaction keeps going – uranium stays HOT

10. CONTROLLED & UNCONTROLLED FISSION
UNCONTROLLED CHAIN REACTION
If the mass of uranium is too large, the rate of the fission reaction increases very rapidly, the temperature rises by thousands of degrees in a fraction of a second and a NUCLEAR EXPLOSION results.
CONTROLLED CHAIN REACTION
If the mass of uranium is a little lower and a material is used to ABSORB EXCESS NEUTRONS, then the rate of fission can be CONTROLLED.
This means the uranium can be kept hot (few hundred degrees) – for years!
“everlasting coal”

11. What is needed to make use of the energy from nuclear fission?
Uranium-235. Natural uranium from mines is mainly U-238 and so must be ENRICHED to raise the % of U-235
1. FUEL RODS – enriched U-235
2.CONTROL RODS (BORON) – ABSORB NEUTRONS.
Lowered – fuel rods cool down
Raised – fuel rods heat up
3.MODERATOR (CARBON) to slow down fast neutrons so they can keep the reaction going
4.Some means of TRANSFERRING the HEAT generated into ELECTRICTY
REACTOR CORE

12. Schematic Nuclear Reactor (MAGNOX type)

13. THICK CONCRETE BIOSHIELDING NEEDED
WATER is usually used as the SECONDARY COOLANT. The steam generated turns turbines. It is not radioactive.
The PRIMARY COOLANT (which carries heat from the core) can be GAS or LIQUID. It becomes RADIOACTIVE

15. An operating reactor with a water moderator
This UNFILLED CORE is made from GRAPHITE
An operating reactor with a water moderator
FUEL RODS (U)
CONTROL RODS (B)

16. Nuclear Energy Issues 1: Solution to Energy Shortage
Enriched uranium releases millions of times the energy released by the same mass of fossil fuel.
Energy is released by the same fuel over a long time period.
If the reactor is properly contained and shielded there are no emissions into the environment.
Nuclear Energy can make a major contribution to supplying our electricity without the emission of GREENHOUSE GASES

17. Nuclear Energy Issues 2: Cost
Due to the need for:
containment of radiation
safety systems with multiple ‘back ups’
security against terrorism
nuclear power stations are very expensive to build, maintain and ‘decommission’

18. Nuclear Energy Issues 3: Waste
The fission products AND their decay products contain many intense short and long half life α,β,γ emitters
Uranium-238 & 235 in fuel are low level alpha emitters
Spent fuel rods comprise HIGH LEVEL WASTE
When a reactor is ‘decomissioned’, the coolant, pipework, reactor vessel materials comprise MEDIUM and LOW LEVEL WASTE

19. Nuclear Energy Issues 3: Waste (ct’d)
Spent fuel rods are stored under water for about 5 years for the most intense radiation to decay, before being converted into ‘glass’ and encased in concrete and steel containers
Low level waste is packed into steel drums and stored on the power station site

20. Nuclear Energy Issues 3: Waste (ct’d)
Nuclear waste remains radioactive for thousands of years. There is no treatment, chemical or physical, that can reduce the radioactivity or speed up the decay process.
It is planned to store the waste UNDERGROUND long term. To date, very few storage sites have been built, due to expense and local opposition.

21. Nuclear Energy Issues 4: Accidents
Although the POSSIBILITY of an accident is very SMALL, the potential DAMAGE an accident could cause is very LARGE.
There is NO possibility of a nuclear explosion (due to the smaller % of U-235 in a reactor compared to a bomb). The main danger is LEAKAGE OF RADIOACTIVE ISOTOPES INTO THE ENVIRONMENT.
Leakage of radioactive steam from a Japanese reactor following an earthquake.

22. Nuclear Energy Issues 4: Accidents
The most serious nuclear accident was in 1986 at Chernobyl in Ukraine.
“The disaster occurred at reactor number four during an unauthorized systems test. A extreme power output surge took place, which led to a reactor vessel rupture and a series of explosions.
This exposed the graphite moderator components to the air and they ignited. The resulting fire sent a plume of radioactive fallout into the atmosphere over large parts of the western Soviet Union, and much of Europe.
As of December 2000, 350,400 people had been evacuated and resettled from the most severely contaminated areas of Belarus, Russia, and Ukraine” Wikipedia

23. Nuclear Energy Issues 4: Accidents
Distribution of Caesium-137 fallout over Europe a few weeks after the Chernobyl incident
The city of Pripyat was evacuated and is still abandoned

24. Nuclear Energy Issues 5: Proliferation
Both Uranium-235 and Plutonium-239 can be used to make nuclear weapons. At present, only a small number of governments have nuclear weapons, but the number may be growing.
The U-235 bomb dropped on Hiroshima in 1945