1. Lesson 2 Reading Guide - KC
Earthquakes and Volcanoes
What causes earthquakes?
What causes volcanoes to form?
How do earthquakes and volcanoes change Earth’s surface?
Lesson 2 Reading Guide - KC

2. Lesson 2 Reading Guide - Vocab
Earthquakes and Volcanoes
earthquake
fault
mid-ocean ridge
hot spot
lava flow
volcanic ash
caldera
Lesson 2 Reading Guide - Vocab

3. Earthquakes
Because tectonic plates move very slowly, most changes to Earth’s surface take a long time.
But some changes occur very quickly and violently.
An earthquake is the rupture and sudden movement of rocks along a break or a crack in Earth’s crust.
1, 2
Lesson 2-1

4. An earthquake can change Earth’s surface quickly and dramatically.3
Lesson 2-1

5. Earthquakes (cont.)
The surface along which the crust moves is called a fault.
When pieces of crust slide past each other, energy is released, causing the ground to shake. 4
Photograph by N.J. Silberling, USGS Photo Library, Denver, CO
Lesson 2-1

6. Earthquakes
Most earthquakes begin in the lithosphere within about 100 km of Earth’s surface.
The focus is the area beneath Earth’s surface where rock that is under stress breaks, triggering an earthquake.
The point on the surface directly above the focus is called the epicenter.
5, 6, 7
Lesson 2-1

7. Earthquakes
Earthquakes release energy in the form of vibrations or waves.
Body waves move through the Earth's interior traveling much more quickly than surface waves.
Surface waves move over Earth's surface.
chart
Lesson 2-1

8. Earthquakes-Types of Body Waves
Primary or P waves are the first energy waves that arrive after an earthquake occurs. They travel through both solids and liquids in a push-pull, linear motion, similar to an earthworm.
Secondary or S waves are the second energy wave that travels through the interior of Earth. They can only travel through solids in an up and down motion.
chart
Lesson 2-1

9. Earthquakes-Types of Surface Waves
Love or L waves: originate at the epicenter of an earthquake and arrive after the secondary waves. They are responsible for the most damage
Rayleigh waves are a second type of surface wave that arrive at a location distant from the epicenter. They travel in a backwards elliptical motion.
chart
Lesson 2-1

10. Most earthquakes occur near plate boundaries, though some occur very far from plate boundaries.9
Lesson 2-1

11. Earthquakes (cont.)
Earthquakes can create new landforms such as mountains.
Compression and tension forces produce ridges and mountains as Earth’s crust moves vertically.
Lesson 2-1

12. Earthquakes (cont.)
Liquefaction refers to when extreme shaking causes ground that is made up of loose sediment to behave more like a liquid than a solid.
Earthquakes can trigger landslides, which bring rocks and soil from the tops of mountains into valleys. 10
Lesson 2-1

14. Earthquakes (cont.)
Earthquakes that happen underwater can cause tsunamis—huge ocean waves created by movement at a fault.
Lesson 2-1

15. Preparedness: Earthquake Safety securing furniture supplies
flashlight
food
water
having a plan

16. Earthquake Safety Buildings: using specific materials that are:
strong, or
can bend with the waves
creating structures that absorb the shock

17. During an Earthquake: Triangle of Life Drop and Cover
Earthquake Safety
During an Earthquake:
Triangle of Life
Drop and Cover

18. Volcanoes
Volcanoes are landforms that form when magma erupts onto Earth’s surface as lava.
Volcanoes can occur at divergent and convergent plate boundaries and at hot spots.
There are approximately 1,500 active volcanoes on Earth.
13, 14, 15
Lesson 2-2

19. The mountains that form as lava from a volcano at a divergent boundary builds up and cools are called mid-ocean ridges. 16
Lesson 2-2

20. At some convergent boundaries, one tectonic plate sinks, melts the mantle, and forms magma that erupts onto the plate that does not sink.
Lesson 2-2

21. Volcanoes (cont.)
Hot spots are locations where volcanoes form far from plate boundaries.
When a hot spot is under oceanic crust, it will form islands such as the Hawaiian Islands.
When a hotspot is under continental crust, it will form a geyser like Old Faithful at Yellowstone National Park in Wyoming. 17
Lesson 2-2

22. Volcanoes (cont.)
Because magma is hot, it is also less dense than the rock material around it.
Rising magma and great pressure caused by dissolved gases eventually erupt through cracks in Earth’s surface, creating a volcano.
18, 19
Lesson 2-3

23. Most of Earth’s largest volcanoes are located at convergent plate boundaries.20
Lesson 2-3

24. Volcanoes (cont.)
When melted mantle material erupts, it flows over Earth’s surface, creating long streams of molten rock called lava flows.
The lava eventually cools and solidifies, forming solid rock. 21
Royalty-Free/CORBIS
Lesson 2-4

25. Volcanoes (cont.)
At convergent plate boundaries, part of the continental crust can become mixed with magma from the mantle.
When this mixture of molten materials erupts, it does not flow as easily as lava made only of melted mantle.
Instead of forming lava flows, it often solidifies in the atmosphere, where it breaks into small pieces of lava called volcanic ash.
22, 23, 24
Lesson 2-4

26. Volcanoes (cont.)
Eruptions that eject ash high into the atmosphere are called explosive eruptions.
Lava also can be produced during these eruptions. 25
Lesson 2-4

27. Before a volcano erupts, magma builds up in the crust in a reservoir called a magma chamber.26
Lesson 2-5

28. Shield volcanoes form after basaltic lava flows have occurred over time.
Shield volcanoes tend to be large with gentle slopes, such as Mauna Loa in Hawaii.
chart
J.S. Griggs/U.S. Geological Survey
Lesson 2-5

29. Composite volcanoes often have steep sides and a cone shape.
Composite volcanoes form as lava flows and ash layers deposited by explosive eruptions build up.
Composite volcanoes often have steep sides and a cone shape.
chart
PhotoLink/Getty Images
Lesson 2-5

30. Sometimes the surface above the chamber collapses, creating a large depression in the center of the volcano called a caldera.
chart
P.W. Lipman, U.S. Geological Survey
Lesson 2-5

31. Volcanic ash and gases from explosive eruptions can blow high into the atmosphere, blocking sunlight.
This can cause the temperature of the atmosphere near Earth’s surface to decrease.
P.W. Lipman, U.S. Geological Survey
Lesson 2-6

32. Earthquakes occur when movement along a fault occurs
Earthquakes occur when movement along a fault occurs. Earthquakes occur mostly along plate boundaries. They can cause great damage.
Volcanoes form at two types of plate boundaries. Lava cools and builds up, forming volcanoes and other landforms.
Lesson 2 - VS

33. Earthquakes and volcanoes change the surface by building mountains, covering land with lava, and shifting the surface along faults.
Lesson 2 - VS

34. 27. Which happens when extreme shaking causes sediment to behave more like a liquid than a solid?
A. compression
B. eruption
C. liquefaction
D. tsunami
Lesson 2 – LR1

35. 28. Which is a long stream of molten rock which eventually cools, solidifies, and builds up over time as flat layers?
A. mid-ocean ridge
B. lava flow
C. fault
D. caldera
Lesson 2 – LR2

36. 29. Which type of volcano often has steep sides and is cone shaped?
A. caldera
B. composite
C. mid-ocean
D. shield
Lesson 2 – LR3

37. 30. Earthquakes occur and volcanoes erupt only near plate boundaries.
Do you agree or disagree?
30. Earthquakes occur and volcanoes erupt only near plate boundaries.
31. Volcanoes erupt melted rock.
Lesson 2 - Now