1. Seismology Part IX: Seismometery

2. Examples of early attempts to record ground motion.

3. Definitions: Seismometer:Transducer from ground motion to something else (usually voltage). Also called geophone. Seismograph:The recording device. Also called Data Logger. Seismogram: The record of ground motion. Seismoscope: (obsolete) Record of ground motion with no time signal (e.g., pendulum in sand)

4. "Classic" devices date back to the late 1800's. Modern (digital) devices have been evolving for the past several decades. A currently used seismometer (CMG-3T) is shown to the right. The goal of any device is to provide a high fidelity record of ground motion, to the extent that an investigator and recreate the actual motion from the record.

5. The Mass on a Spring (Inertial Pendulum) The simplest kind of transducer is a mass suspended from a casing by a spring. The casing will move with the ground, and the spring provides some kind of decoupling. To understand what happens, we consider Hooke's law: F = -ky(t) where y(t) is the displacement of the mass from its equilibrium position. Thus describes the unforced (homogeneous) and undamped oscillations of the mass. We recognize this immediately as a simple wave equation with the solution:

6. where Generally, we will concern ourselves with an oscillator driven by a ground motion U(t), and with a damping force proportional to the velocity of the mass, and modify the above to be: or where

7. If we amplify the ground motion by a factor G, then We consider, without loss of generality, the response to a sinusoidal input: and consider a solution of the form X(  )e -i  t to get

8. Note that the response is a maximum when  =  o (it blows up with no damping). This is called the resonance or characteristic frequency of the system. If  1, the response x(t) will not oscillate at all but gradually return to zero. If  = 1, the oscillations are critically damped.

9. Note that if  <<  o, then which means that acceleration is transduced with no phase shift. Thus, accelerometers are designed with very high resonant frequencies.

10. If  >>  o, then and so the sensor is directly proportional to ground displacement (the  phase shift means that the mass motion is in the opposite direction of U). The instrument thus responds best to motion with periods near the natural period, and the width of the response will depend on the damping.

11. Electromagnetic Instruments Electromagnetic transducers operate by the relative motion of a magnet and a coil, which produces a current in the coil. The effect is generally to modify the above equations with an additional  term, because the signal generated will be proportional to the velocity of the mass. Examples: WWSSN: Sensor, galvanometer, photo paper Geoscope/GSN: Force feedback sensors; digital IDA:Force feedback gravity meter; digital

13. NORSAR

14. ..\Pix\USArray6.mov US National Seismic Network USArray