1. Features. ► Support 1 to 4 channels video input. ► Built-in GPS, G sensor ► Built-in wireless module like 3G (EVDO, HSPA, HSDPA), GPRS, WiFi ► G.726 audio compression, 4CH audio input, 1CH audio output. ► 6CH alarm input (Level input), 1CH alarm output (Relay output) ► RS232 interface for remote control; RJ45 10M/100M Ethernet port. ► Storage: Maximum 1pcs 2.5” hard disk with removable hdd housing plus 1pcs 32 GB SD card. Support HDD heater funtion ► With anti-vibration and anti-high temperature protection, the quality of video files is always guaranteed ► Dimensions: 160(W) x200(H) x62(D) mm Weight: 2200g

2. . MOBILE DVR CCTV Cameras Onboard Monitoring Wide range of vehicles in your fleet Can be connected Cellular TowerWI-FI AntennaServer Desktop Client Laptop Client GPS Satellite

3. Up to 4 Cameras can be installed anywhere on the vehicle

4. GPS: The system comes standard with a GPS Receiver

5. Full Video Playback and GPS Playback on map

6. Remote File Downloading and System Upgrades

7. Recording. Time Record: Recording can be set for different time intervals. Auto Record:Recording will automatically start and stop with ignition. Stop recording delay can be set up to 4 hours after ignition has been switched off. Alarm/Event Record:Recording can be set for various alarms or events such as door open, over speeding, movement, motion detection, etc. Alarm recordings are set to pre-record 15 seconds before alarm and can be adjusted to between 30 seconds and 30 minutes after alarm.

8. . Manual Record:Recording can manually be activated or de-activated from the control room. Audio Record:Audio can be activated or de-activated from the control room.

9. . DATA DOWNLOADING / TRANSMISSION The system comes standard with a built in 3G/GPRS/EDGE/WI-FI wireless transmission module. Data can be transmitted via the cellular network at any time or through WI-FI when the vehicle enters the premises. The system is equipped with anti-vibration protection to guarantee the quality of the video files. G-SENSOR The standard impact sensor will record and transmit data on impact 15 seconds before and up to 30 minutes after.

10. . AUDIO/VOICE COMMUNICATION The system comes standard with a 2 ways voice communication module. The audio can either be connected to your FM radio system or an external speaker and microphone can be installed. When connecting to your FM radio the radio will automatically be silenced by the system when a call is made and the audio will be transmitted via your radio system. POWER SUPPLY/CONSUMPTION The system can operate on 8V – 36V and is therefore compatible with all vehicles. The system uses less than 10watt in normal working state and less than 0.5watt in standby mode.