2. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Engine Manufacturers’ Engine Compliance Roundtable June 28 th, 2006 FAPT

3. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Al Ambrosini Manager, Engine Marketing International Truck and Engine Corporation

4. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Emissions Technology Hardware Strategies VG Turbo – CAC – EGR – DOC – DPF –

5. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology DOC DPF Temperature Sensor T1 Pressure Differential Sensor Temperature Sensor T2 Temperature Sensor T3 3 Bolt Flange International Exhaust Configurations

6. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Active Re-Generation In cylinder dosing –Existing fuel injector adds a “dose” of fuel into the cylinder after the primary combustion has taken place –Unburned fuel is exhausted out of the cylinder down to the DOC where it burns and generates additional heat for the DPF –This additional heat in the DPF helps to convert the soot into ash. Ash has lower volume and back pressure than soot

7. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Emissions Technology Engine Oil Specifications (CJ-4) Technical Requirements – Limits on SAPS –Sulfated Ash –Phosphorus –Sulfur Required to prevent catalyst poisoning and extend DPF service interval Total Base Number (TBN) will be 8 to 9, whereas CI-4 Plus has a TBN of 10-12. This should be offset with the ULSD Estimated availability for CJ-4 is October, 2006 Will be backward compatible with pre-2007 engines

8. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Service Strategy for 2007 No change in oil drain or other service intervals New engines will require CJ-4 oil –CJ-4 will be backward compatible for older equipment –Older CI-4 oil: Likely will still be widely available May be significantly cheaper (Present estimates show CJ-4 to cost anywhere from 15 to 30% more than CI-4)

9. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology “Always Performing” ™

10. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology ™ DT 466MaxxForce DT

11. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology

12. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Leading The World In Diesel Engine Technology MAXXFORCE DT MAXXFORCE 9 MAXXFORCE 10 MAXXFORCE 11 MAXXFORCE 13 MAXXFORCE 5MAXXFORCE 7  Naming will go into effect with 2007 engines  Engines will be black/aluminum in appearance  Badge will retain “Blue” image

13. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What stayed the same into 2004? Bore Diameter Stroke

14. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What was new in 2004? Crankcase Cylinder Head Crank Shaft Valve Train Fuel System Turbochargers EGR System If you can point to it, it was new.

15. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology So Here We Go Again in 2007?

16. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What stays the same this time? Crankcase Cylinder Head Crankshaft Valve Train Fuel System Turbocharger If you can point to it, it hasn’t changed (or hasn’t changed much)

17. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What’s new? Reliability Improvements Minor improvements to existing parts for improved reliability and durability Where possible, these are being launched prior to 2007

18. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What’s New? Active Regeneration Strategy Level One – Adjust parameters to raise exhaust temperature Level Two – In Cylinder Dosing –Late fuel injection –Fuel exits with exhaust and combusts in DOC –No Additional Hardware or Fuel Lines Required

19. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What’s new Engine Controller –Added capability for control of after-treatment –32 bit processor –Expanded Features

20. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What’s new Intake Throttle –Helps control active regeneration process Helps raise exhaust temperature for Active Regeneration Protects DPF from high temperature damage

21. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What’s new Increased EGR system capacity –Builds upon successful 2004 EGR system –Adds a second EGR cooler on Intake side of engine for NOx emissions reduction

22. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology What’s new Closed breather Centrifugal Separator Driven by Oil Pressure Very high efficiency No Service Required Mounted to crank case Similar to breather Mack and DDC will offer

23. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Molded Foam Wiring Harness Highest Quality Robust to chaffing and damage Easy to assemble and service Wiring has been a top reliability issue

24. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Belt Drive 10 Groove belt replaces 8 groove Improves belt life and allows additional accessory loads

25. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology New Features for 2007 Dual Air Conditioning Compressors from factory Engine mounted Uses Sanden “Enhanced” SD7 Compressors (higher volumetric efficiency)

26. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology New Features for 2007 Top Loading Fuel Strainer Less Mess Easy Access

27. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology MaxxForce DT Product Positioning 73/7400 43/4400 Characteristics Configuration I6 Displacement7.6L (466 cu in) Power Output 210 - 300hp @ 2400 – 2600 rpm Peak Torque520 – 860 ft lbs. @ 1450 rpm AspirationTurbocharged Combustion System Direct Injection B10 / B50 Life300,000 / 450,000 miles Dry Engine Weight 1480 lbs. 3200 MaxxForce DT CE FE RE

28. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology MaxxForce DT The same great engines from International ™

29. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Aftertreatment Control System User Interface Passive Regeneration – No driver Notification Active Regeneration – No driver Notification Forced or Manual Regeneration – Driver must be notified –This mode is not available to the driver during the normal driving cycle and requires additional vehicle level logic to work with the engine and aftertreatment controls to start the regeneration. This mode is performed in a standstill operation. –But what if I cannot perform this process now? The vehicle will allow a certain amount of time before this process MUST be started. Additional warning levels and feedback will be provided to the driver to ensure that the filter and engine do not become damaged including de-rate of the engine to protect these sensitive systems

30. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Stationary or Forced Regeneration –Interlocks: To ensure that the driver is in a safe environment and that the driver acknowledges that control of the vehicle will not be available to him until the STATIONARY regeneration is complete, International has devised a series of vehicle level controls to ensure that this procedure is both started and completed accurately Interlocks include: –Vehicle Speed = 0 –Engine Speed Control NOT engaged –Park Brake SET –Automatic Transmission in NEUTRAL or PARK –Brake Pedal NOT depressed –Clutch Pedal NOT depressed –Throttle Pedal NOT depressed –STATIONARY REGENERATION REQUEST BUTTON PRESSED If any of these conditions are NOT met, the Request Button will flash, indicating the driver has started the process incorrectly, and the process will NOT start Aftertreatment Control System User Interface

31. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology PM reduction (plus HC & CO) Not an exothermic device Max T exh = 625C (1150F) at Peak Torque Idle T exh = 180C (360F) DOC Current Diesel Engine DOC is exothermic for regen DPF filters & stores PM Max T exh = 650C (1200F) during Regeneration Idle T exh = 180C (360F) except during regen DOC + DPF DOC 2007 Diesel Engine DPF Maximum Exhaust Temp’s Current vs. 2007 Diesel Engines

32. CLEARING THE AIR ON 2007 EMISSIONS Leading The World In Diesel Engine Technology Maximum Exhaust Temperature 2007 Targets Skin temperatures: Same as today Exit exhaust gas temperatures: Not to exceed 400° C (750° F)