1. Hazardous Waste Management Refresher Training

2. Environmental Stewardship It is the responsibility of all employees to manage chemical waste in a reasonable manner. Failure to do so can result in harm to other employees and/or destruction of work areas due to fires, explosions, or spills.

3. Resource Conservation and Recovery Act (RCRA) RCRA govern handling and disposal procedures of certain laboratory wastes that are categorized as hazardous. USPSNL is considered a small quantity generator of hazardous waste, which means less than 100 kg or 22 pounds of hazardous waste is produced per month.

4. Section I Waste Determination

5. Solid Waste vs. Hazardous Waste Solid Waste : A solid, semi-solid, liquid, sludge, or contained gas, that is no longer needed, to be discarded, or has served its useful purpose. Hazardous Waste : A solid waste that is listed by the EPA or exhibits one or more of four characteristics. IgnitableCorrosiveReactiveToxic

6. Hazardous Waste is only a small portion of the waste generated in the workplace, but by far the most harmful to the nature and the environment.

7. Listed Hazardous Waste Complete lists of hazardous waste are located in your Chemical Hygiene Manual and with the Cluster Environmental Protection Specialists.

8. Hazardous Waste Determination A chemical waste may also be classified as hazardous if it exhibits one or more of the following characteristics: LIgnitability LCorrosivity LReactivity LToxicity

9. Characteristic Hazardous Waste Ignitable Wastes LIs a liquid with a flashpoint of 140°F or below (alcohols containing less than 24% alcohol by volume are not considered ignitable); or, LIs a flammable or ignitable compressed gas

10. Characteristic Hazardous Waste Corrosive Wastes LIs an aqueous solution (a solution having more than 50% water) with a pH less than or equal to 2.0 or greater than or equal to 12.5; or, LA solid waste capable of corroding steel at specified conditions.

11. Characteristic Hazardous Waste Reactive Wastes LIs normally unstable and readily undergoes violent change without detonating; or, LReacts violently with water

12. Characteristic Hazardous Waste Toxic Wastes LUsing the Toxicity Characteristic Leaching Procedure the concentration of contaminants are equal to or greater than the regulatory levels identified in 40 CFR 261.24, Table 1. (or you can get the list from Kathie Moh)

13. Section II Waste Minimization

14. What is Waste Minimization? Waste minimization includes: source reduction practices that reduce or eliminate waste generation at the source; and environmentally sound recycling practices, where source reduction is not economically practical.

15. Source Reduction includes any practice that reduces the quantity and/or toxicity of pollutants entering a waste stream prior to recycling, treatment, or disposal.

16. Examples of Source Reduction equipment or technology modifications, reformulation or redesign of products, substitution of less toxic raw materials, improvements in work practices, maintenance, better inventory control.

17. Recycling includes the use, reuse and/or reclamation of waste residuals (that may be designated as a hazardous waste) or materials in a hazardous waste.

18. A material is “ used or reused ” if it is used as an ingredient in a process to make a product or, or if it is used as an effective substitute for a commercial product.

19. A material is “ reclaimed ” if it is processed to recover a usable product, or if it is regenerated.

20. How Can “You” Minimize Waste? Plan ahead Order only the amount needed Avoid storing excess chemicals Share unneeded chemicals Keep chemicals properly labeled

21. Why Minimize Waste? Reduce costs Increase process efficiency and productivity Reduce present and future regulatory burdens Improve workplace safety Improve environmental quality Maintain or improve institutional image

22. Section III How to Manage and Contain Waste

23. Satellite Accumulation Areas (SAA) All containers of hazardous waste must be stored in an area designated as a satellite accumulation area. Satellite accumulation areas must be established in the area where the waste was generated and under the direct control of the individual who generated the waste.

24. Accumulation Limits in SAA’s A SAA may accumulate: –55 gallons of non-acute waste –Up to 1 quart of acutely hazardous waste There is no limit as to how long waste may be accumulated in each waste container in a SAA. However, once the container is full and/or the above stated limits are exceeded the waste must be removed from the work area within three working days.

25. Condition of Hazardous Waste Containers Containers must be in good condition, Have no rust, pinholes, dents, leaks, or chemical deposits on the outside, Container cap must be free of cracks and seals tightly – no corks, stoppers, foil, and parafilm, Container can not leak if inverted – no beakers, flasks, or coffee cans

26. Accumulation of Chemical Hazardous Waste Keep hazardous waste containers closed All containers of chemical hazardous waste must be closed at all times except when waste is being added or removed from the container.

27. Section IV How to Properly Dispose of Chemical Wastes

28. Predisposal Procedures Sorted by compatibility In approved containers Tighten caps Ensure contents are properly identified

29. Example of a properly completed label These Cornell waste label forms are and only for chemical waste. Full names of the chemical components are listed along with the relative amounts Correct chemical type is checked All the contact information is complete

30. Disposal Procedures Move to a Satellite Accumulation Area (SAA) Once there are no more room in the SAA, move the waste to the storage cabinet in the shipping/receiving room, G-26. Give the copy of the Cornell waste label to Kathie Moh, or the CEPS or the CDSO officer

31. You’re Almost Done Make sure you fill out the quiz and drop it off in my mailbox for record keeping. Remember: This is an annual requirement. SEE YOU NEXT YEAR

32. Questions Contact: Kathie Moh 255-8849 kcm25@cornell.edu