Presentation is loading. Please wait.

Presentation is loading. Please wait.

Performance Objectives  Understand the technology and operating principles of the Stun Cuff  Understand the application and expected effect of use on.

Similar presentations


Presentation on theme: "Performance Objectives  Understand the technology and operating principles of the Stun Cuff  Understand the application and expected effect of use on."— Presentation transcript:

1

2 Performance Objectives  Understand the technology and operating principles of the Stun Cuff  Understand the application and expected effect of use on Offenders  Understand and review Use of Force Options 300-16RD

3 Performance Objectives  Be aware of use/ effects of the technology on offenders where certain medical conditions/ considerations may exist.  Understand post incident procedures following activation and firing of the Stun Cuff.

4  Multi-Cuff Transmitter  Magnum Plus with Dataport System

5  Light-weight unit  Can be re-activated after initial cycle  2 step activation process  Decreases the possibility of injury to both the Officer and the Offender

6  2-3 Second 80,000 Volt / 5 milliamp output  Can reactivate w/in 10 seconds of initial stun  Activator will produce a longer stun if needed  Activator will produce multiple stuns on demand  100 yard range

7  10 minute battery  Unit shows Green signal LED/red at low power  Activate through barriers  2 step fail safe operation  100 yard range

8  The Stun-Cuff is a device designed for the temporary, non-lethal incapacitation of a violent or resisting individual.  The use of a Stun-Cuff will not violate a prisoner’s rights provided it is used as intended and within DOC use of force policy.

9  Any possible accidental activation must be avoided.  The Stun-Cuff will not injure an offender; however, as with any use of force, secondary and indirect injuries can occur.

10  Application of any Electronic Incapacitation Device (EID) will leave marks.  EIDs have a place in the traditional force continuum.

11  Psychological Intimidation  Verbal Non- Compliance  Passive Resistance  Defensive Resistance  Active Aggression  Deadly Force Assault  Escape

12  Officer Presence  Verbal Direction  Soft Empty Hand Control  Hard Empty Hand Control  Soft Intermediate Control Device  Hard Intermediate Control Device  Lethal Force

13 1. Reduces physical confrontation 2. Decreases resistance 3. Impairs an offender 4. Decreases injury potential

14 1. Court 2. Hospital Supervision 3. Transports

15  When can the Stun Cuff be applied to an offender?

16  What classification levels require the Stun-Cuff to be placed on the offender?

17  What offenders is the Stun- Cuff not authorized?

18  Any woman known or claiming to be pregnant.  Any person claiming to have a serious heart disease.  Any person claiming to have Muscular Dystrophy or Multiple Sclerosis.

19  Placement with standard handcuff key  Directly over shirt sleeve/sock or direct to skin  Cuff placed on inside of forearm/over Achilles

20  Placed directly over a shirt sleeve or directly to the skin.  Place the cuff on the INSIDE of the forearm.  Electrical points facing away from the palm  Strap firm but not overly tighten

21 The electrical points should be facing away from the palm.

22  Place the Stun-Cuff over the sock, toward the Achilles Tendon  Electrical points facing upward and away from the foot  Strap firm but not overly tight.

23 Electrical points facing upward and away from the foot.

24 1. Turn the device on. 2. Pass the bottom of the remote control over the LED light on the Stun-Cuff. 3. The Green power light will come on. 4. Press the “ON” button and hold until the Green light flickers.* 5. The Green LED light will flash every 2- 3 seconds to show it is in “ON” mode.**

25  Proper method to activate the device for a shock test or for an actual use of force

26 1. To trigger an electrical shock, press the “ON” button. 2. Press the “FIRE” button within 10 seconds of pressing the “ON” button.* 3. Holding the “FIRE” button down will cause a longer shock.** 4. Another shock can be delivered if the initial delivery was less than 10 seconds.

27

28  Once the cuff is no longer needed you will need to turn the device off

29  The remote control and stun cuff will need to be charged when the green LED light turns RED

30  Read to the Offender  Offender does not have to sign  Stun-Cuff is placed on the Offender regardless of the Offenders signed acknowledgement

31  When can/should the Stun-Cuff be activated?

32  If the stun cuff is activated what will/may happen, will signature marks be present?  What should staff do with the offender after a shock has been given?

33  A PCDCIS Report must be completed in accordance with Administrative Regulation 100- 07.  Any staff report of injuries must accompany a First Report of Injury packet.

34  Questions?  Practical – Static Activation  Written Test


Download ppt "Performance Objectives  Understand the technology and operating principles of the Stun Cuff  Understand the application and expected effect of use on."

Similar presentations


Ads by Google