1. Welding Equipment UVU CRT 2009

2. Welder  The welder used in the Spanish Fork High Collision Repair Shop is a 135 amp wire feed Metal Inert Gas (MIG) welder. UVU CRT 2009

3. Shielding Gas  A 75% Argon 25% Carbon Dioxide (C25) gas is used to protect the weld puddle from contaminates.  This mix gives a quality flat weld that is beneficial for collision work. UVU CRT 2009

4. Gas Regulator  This is the pressurized gas regulator.  The optimum flow setting is 17 cubic feet/minute. UVU CRT 2009

5. Inside the Welder .023 Continuous Wire Spool.  Leads to reverse the weld polarity.  Wire Tension Control UVU CRT 2009

6. Welding Gun Assembly Gas Nozzle Contact Tip.023 Wire Liner Gas Diffuser UVU CRT 2009

7. Contact Tip  Wire feeds through the contact tip which provides the electrical contact.  The contact tip is a wear item that should be replaced occasionally. UVU CRT 2009

8. Gas Nozzle  Used to focus the shielding gas over the weld puddle. UVU CRT 2009

9. Wire Liner  The wire feeds through the liner to the contact tip.  The liner is also a wear item that should be replaced when the wire feed is irregular. UVU CRT 2009

10. Welding Pliers  Combination style pliers for cutting welding wire and tightening contact tips etc. UVU CRT 2009

11. Clecos  Reusable blind rivet system used to secure overlapping panels. UVU CRT 2009

12. Air Drill  Drill 1/8” holes for the Clecos.  Drill 5/16” holes for spot welds UVU CRT 2009

13. Cut Off Tool  Abrasive disc used to cut sheet metal panels. UVU CRT 2009

14. Tin Snips  Aviation tin snips allow right and left hand cuts without deforming the metal. UVU CRT 2009

15. Roloc Angle Grinder  Roloc discs are designed to remove surface contaminates from the metal without thinning the metal. UVU CRT 2009

16. Panel Crimper  Used to crimp the edge of the panel for an offset lap weld. UVU CRT 2009

17. Vice Grips  Holding and securing panels for welding. UVU CRT 2009

18. Metal Hole Punch  5/16” Metal Hole Punch.  Used for making holes in sheet metal for plug welds. UVU CRT 2009

19. Welding Tools  These are the basic tools that will be used to perform the welds required for completion of the welding and cutting steel module.  We will discuss there correct use in the lab portion of the class. UVU CRT 2009

20. References  Miller Electric Mfg. Co. Education. http://www.millerwelds.com/education/library.html, 2006. http://www.millerwelds.com/education/library.html  Lincoln Electric Co. Lincoln Welders. http://www.lincolnelectric.com/, 2006. http://www.lincolnelectric.com/  Inter Industry Conference on Automotive Collision Repair. I-CAR Online Training. http://www.i-car.com/, 2006.http://www.i-car.com/ UVU CRT 2009