1. NI ELVIS II Quick Start Training

2. Contents Setting up Procedure On-Board elements of NI Elvis II Workstation Features

3. Setting up procedure 1)First, install application development software (if applicable). Then install ELVISmx driver software (Windows Only). 2)Install the prototyping board.

4. 3)Connect the enclosed power supply to the NI ELVIS II workstation, then plug the power supply into a wall outlet. 4)Use the enclosed USB cable to connect to a PC. Cont’

5. 5)Power on the NI ELVIS II workstation. Make sure both power switches are ON in order to work with the NI ELVIS II workstation. 6)Use a BNC cable (not included) to make the connections shown. Cont’

6. 7)Use jumper wires (not included) to make the connections shown. 8)Select Start»All Programs»National Instruments»NI ELVISmx»NI ELVISmx Instrument Launcher. Click Function Generator and Oscilloscope. Cont’

7. Configure the Function Generator instrument panel and click Run. Configure the Oscilloscope instrument panel as shown and click Run. Observe the generated sine wave.

8. On the Function Generator instrument panel, click Stop and configure as shown. Click Run. On the Oscilloscope instrument panel, configure as shown. Observe the change in the signal. Cont’

9. On-Board elements of NI Elvis II

10. Workstation Features Workstation Power Switch Prototyping Board Power Switch Digital Multimeter (DMM) Connectors Breadboard Function Generator (FGEN) Power Supplies

11. Workstation Features