1. Induction and Inductance Chapter 30

2. Magnetic Flux

3. Insert Magnet into Coil

4. Remove Coil from Field Region

5. A changing magnetic field INDUCES a current in a circuit loop.
From The Demo ..
First experiment
Second experiment
A changing magnetic field INDUCES
a current in a circuit loop.

6. Faraday’s Experiments?

7. That’s Strange …..
These two coils are perpendicular to each other

8. Definition of TOTAL ELECTRIC FLUX through a surface:

9. passing through a surface.
Magnetic Flux: F
THINK OF
MAGNETIC FLUX
as the
“AMOUNT of Magnetism”
passing through a surface.

10. Consider a Loop Magnetic field passing through the loop is CHANGING.
FLUX is changing.
There is an emf developed around the loop.
A current develops (as we saw in demo)
Work has to be done to move a charge completely around the loop.
xxxxxxxxxxxxxxx

11. Faraday’s Law (Michael Faraday)
For a current to flow around the circuit, there must be an emf.
(An emf is a voltage)
The voltage is found to increase as the rate of change of flux increases.
xxxxxxxxxxxxxxx

12. Faraday’s Law (Michael Faraday)
xxxxxxxxxxxxxxx
We will get to the minus sign in a short time.

13. Faraday’s Law (The Minus Sign)
xxxxxxxxxxxxxxx
Using the right hand rule, we
would expect the direction
of the current to be in the
direction of the arrow shown.

14. Faraday’s Law (More on the Minus Sign)
The minus sign means that the current goes the other way.
xxxxxxxxxxxxxxx
This current will produce a magnetic field that would be coming OUT of the page.
The Induced Current therefore creates a magnetic field that OPPOSES the attempt to INCREASE the magnetic field! This is referred to as Lenz’s Law.

15. How much work? Faraday's Law emf xxxxxxxxxxxxxxx
A magnetic field and an electric field are
intimately connected.)

16. MAGNETIC FLUX This is an integral over an OPEN Surface.
Magnetic Flux is a Scalar
The UNIT of FLUX is the weber
1 weber = 1 T-m2

17. We finally stated
FARADAY’s LAW

18. From the equation
Lentz
Lentz

19. Flux Can Change If B changes If the AREA of the loop changes
Changes cause emf s and currents and consequently there are connections between E and B fields
These are expressed in Maxwells Equations

20. Maxwell’s Equations (chapter 32 .. Just a Preview!)
Gauss
Faraday

21. Another View Of That hopeless minus sign again …
Another View Of That hopeless minus sign again …..SUPPOSE that B begins to INCREASE its MAGNITUDE INTO THE PAGE
xxxxxxxxxxxxxxx
The Flux into the page begins to increase.
An emf is induced around a loop
A current will flow
That current will create a new magnetic field.
THAT new field will change the magnetic flux.

22. Lenz’s Law
Induced Magnetic Fields always FIGHT to stop what you are trying to do!

23. Example of Lenz The induced magnetic field opposes the
field that does the inducing!

25. Don’t Hurt Yourself!
The current i induced in the loop has the direction
such that the current’s magnetic field Bi opposes the
change in the magnetic field B inducing the current.

26. Lenz’s Law An induced current has a direction
such that the magnetic field due to
the current opposes the change in
the magnetic flux that induces the
current. (The result of the negative sign!) …

27. #1 CHAPTER 30 The field in the diagram creates a flux given by
FB=6t2+7t in milliWebers
and t is in seconds.
What is the emf when
t=2 seconds?
(b) What is the direction
of the current in the
resistor R?

28. This is an easy one …
Direction? B is out of the screen and increasing.
Current will produce a field INTO the paper
(LENZ). Therefore current goes clockwise and R
to left in the resistor.

29. #21 Figure 30-50 shows two parallel loops of wire having a common axis
#21 Figure shows two parallel loops of wire having a common axis. The smaller loop (radius r) is above the larger loop (radius R) by a distance x >>   R. Consequently, the magnetic field due to the current i in the larger loop is nearly constant throughout the smaller loop. Suppose that x is increasing at the constant rate of dx/dt = v. (a) Determine the magnetic flux through the area bounded by the smaller loop as a function of x. (Hint: See Eq ) In the smaller loop, find (b) the induced emf and (c) the direction of the induced current. v

30. q
B is assumed to be constant through the center of the small loop and caused by the large one.

31. The calculation of Bz q

32. More Work
In the small loop:
dx/dt=v

33. Which Way is Current in small loop expected to flow??q B

34. What Happens Here? Begin to move handle as shown.
Flux through the loop decreases.
Current is induced which opposed this decrease – current tries to re-establish the B field.

35. moving the bar

36. Moving the Bar takes work

37. What about a SOLID loop?? Eddy Currents Energy is LOST BRAKING SYSTEM
METAL
Pull
Eddy Currents

38. Inductors
Back to Circuits for a bit ….

39. Definition Current in loop produces a magnetic field
in the coil and consequently a magnetic flux.
If we attempt to change the current, an emf
will be induced in the loops which will tend to
oppose the change in current.
This this acts like a “resistor” for changes in current!

40. Remember Faraday’s Law
Lentz

41. Look at the following circuit:
Switch is open
NO current flows in the circuit.
All is at peace!

42. Close the circuit…
After the circuit has been close for a long time, the current settles down.
Since the current is constant, the flux through the coil is constant and there is no Emf.
Current is simply E/R (Ohm’s Law)

43. Close the circuit…
When switch is first closed, current begins to flow rapidly.
The flux through the inductor changes rapidly.
An emf is created in the coil that opposes the increase in current.
The net potential difference across the resistor is the battery emf opposed by the emf of the coil.

44. Close the circuit…

45. Moving right along …

46. Definition of Inductance L
UNIT of Inductance = 1 Henry = 1 T- m2/A
FB is the flux near the center of one of the coils
making the inductor

47. Consider a Solenoid l
n turns per unit length

48. So…. Depends only on geometry just like C and
is independent of current.

49. Inductive Circuit i Switch to “a”.
Inductor seems like a short so current rises quickly.
Field increases in L and reverse emf is generated.
Eventually, i maxes out and back emf ceases.
Steady State Current after this.

50. THE BIG INDUCTION As we begin to increase the current in the coil
The current in the first coil produces a magnetic field in the second coil
Which tries to create a current which will reduce the field it is experiences
And so resists the increase in current.

51. Back to the real world…
Switch to “a” i

52. Solution

53. Switch position “b”

54. Max Current Rate of
increase = max emf
VR=iR
~current

55. Solve the loop equation.

56. IMPORTANT QUESTION Switch closes. No emf Current flows for a while
It flows through R
Energy is conserved (i2R)
WHERE DOES THE ENERGY COME FROM??

57. For an answer Return to the Big C+q -q
E=e0A/d
+dq
We move a charge dq from the (-) plate to the (+) one.
The (-) plate becomes more (-)
The (+) plate becomes more (+).
dW=Fd=dq x E x d

58. The calc
The energy is in
the FIELD !!!

59. What about POWER?? power to circuit power dissipated by resistor
Must be dWL/dt

60. So
Energy
stored
in the
Coil

61. WHERE is the energy?? l

62. Remember the Inductor??
?????????????

63. So …

64. ENERGY IN THE FIELD TOO!

65. IMPORTANT CONCLUSION
A region of space that contains either a magnetic or an electric field contains electromagnetic energy.
The energy density of either is proportional to the square of the field strength.

66. 10. A uniform magnetic field B increases in magnitude with time t as given by Fig b, where the vertical axis scale is set by Bs=9 mT and the horizontal scale is set by ts=3 s . A circular conducting loop of area A= 8x10-4 m2 lies in the field, in the plane of the page. The amount of charge q passing point A on the loop is given in Fig c as a function of t, with the vertical axis scale set by qs=3 mC and the horizontal axis scale again set by ts=3 s. What is the loop's resistance?

67. 29.  If 50.0 cm of copper wire (diameter=1mm ) is formed into a circular loop and placed perpendicular to a uniform magnetic field that is increasing at the constant rate of 10.0 mT/s, at what rate is thermal energy generated in the loop?

68. fini