1. Microscopic Analysis of Bacterial Motility at High Pressure
Masayoshi Nishiyama, Yoshiyuki Sowa 
Biophysical Journal 
Volume 102, Issue 8, Pages (April 2012)
DOI: /j.bpj
Copyright © 2012 Biophysical Society Terms and Conditions

2. Figure 1
High-pressure microscope. (A) Cross section of a high-pressure chamber (HPC). MB, main body; WS, window support; OW, observation window; RW, rear window; BR, backup ring; O, O-ring. (B) Photographs of the HPC. (Left) Disassembled components of the HPC with a coin (diameter 23.5 mm) shown for size comparison. (Right) HPC mounted on an inverted microscope; full details of the microscope stage are available to interested parties upon request. A white arrow indicates the pressure line connected to the hand pump. (C) Various microscopic images of the same 1-μm beads at 100 MPa. These images were recorded at 30 frames s−1 and displayed without processing contrast enhancement and brightness offset. (D) Intensity profile of the bead at 0.1 (open circles) and 100 MPa (solid circles). The intensity profile of the same bead was plotted at each pixel in the x direction. The arrows in C indicate the corresponding original images.
Biophysical Journal  , DOI: ( /j.bpj )
Copyright © 2012 Biophysical Society Terms and Conditions

3. Figure 2
Motility of smooth-swimming cells. (A) Trajectories of RP4979 cells. The positions of the cell were plotted every 10th frame for 5 s. (Inset) Trajectory of a cell at 80 MPa for 5 s on an expanded scale. Scale bar, 2 μm. (B) 2MSDs plotted at every frame for 5 s (40 and 60 MPa) or every 10 frames (70 and 80 MPa) (n = 46–59, total = 202). Data were fitted by (vt)2 and/or 4Dx–yt, where v is the translational speed, Dx–y is the diffusion constant, and t is time (40 MPa, v = 11 μm s−1; 60 MPa, v = 5.2 μm s−1; 70 MPa, v = 1.0 μm s−1 and Dx–y = 0.35 μm2 s−1; 80 MPa, Dx–y = 0.25 μm2 s−1). (C and D) Swimming fraction and speed during the pressurization (solid circles) and depressurization processes (open diamonds). Swimming fractions were based on the number of cells that swam with a speed of >2 μm s−1 at each pressure. The speed was the average value of the swimming cells in C. Error bars represent the SD.
Biophysical Journal  , DOI: ( /j.bpj )
Copyright © 2012 Biophysical Society Terms and Conditions

4. Figure 3
Rapid recovery of motility in RP4979 cells. (A and B) Swimming fraction and speed after the release of pressure (mean ± SD, n = 22–52). Before the application of pressure, all of the cells swam smoothly (open circles). Pressure of 80 MPa was applied to the cells for 5 min (open square in gray area) and then instantaneously decreased to 0.1 MPa at t = 0. The plots (solid circles) could be fitted by an exponential curve with τ = 4.9 s (A) and 5.6 s (B) Error bars represent the SD.
Biophysical Journal  , DOI: ( /j.bpj )
Copyright © 2012 Biophysical Society Terms and Conditions

5. Figure 4
Torque generation of single flagellar motors in strain YS1326 (A–E) and YS1217 (F and G). (A and B) Sequential phase-contrast images of the same rotating tethered cell were taken at every frame. The pressure was 0.1 MPa (A) or 80 MPa (B). Arrowheads indicate completion of a turn. Scale bars, 2 μm. (C) Time courses of revolutions of the same cell in A and B (CCW positive). (D) Histograms of the rotational speed (n = 130). The speeds of the motors rotating in the CCW direction were taken as positive. Data for the motors that were in the stop state were colored gray in the histograms. (E) Pressure and speed relation in the pressurization (circles) and depressurization processes (diamonds). (F and G) Rotational speed at different expression levels of stator units. The expression levels of stator units in YS1217 cells were controlled by adding 5 (circles; n = 45), 10 (triangles; n = 48), 50 (diamonds; n = 50) and 100 (squares; n = 61) μM arabinose. (G) Normalized speed. Data for cells whose motors were stopped were excluded from calculations of speed (E–G).
Biophysical Journal  , DOI: ( /j.bpj )
Copyright © 2012 Biophysical Society Terms and Conditions

6. Figure 5
High-speed rotation at low viscous drag. (A) Time courses of y-displacement (left) and xy plots (right) of the same rotating gold colloid bead at 0.1 (open circles) and 80 (solid circles) MPa. (B) Time courses of revolutions of the same motor represented in A (CCW positive). (C) Rotational speed of individual flagella during the pressurization (solid circles) and depressurization processes (open diamonds). Each speed was obtained from the number of rotations over 2 s (n = 10). Error bars represent the SD.
Biophysical Journal  , DOI: ( /j.bpj )
Copyright © 2012 Biophysical Society Terms and Conditions