1. Unit 5: Chemical Kinetics
Day 7: Kinetics Lab

2. Warm Up Absorbance = 3. 5E-3. (Conc. ) + 0
Warm Up Absorbance = 3.5E-3*(Conc.) Use the equation above to solve for concentration in the table below
ABSORBANCE
CONCENTRATION (mol/L)
0.87
0.75
0.43
Answer: b

3. Warm Up 2-23 Absorbance = 3. 5E-3. (Conc. ) + 0
Warm Up 2-23 Absorbance = 3.5E-3*(Conc.) Hint: Rearrange Equation
ABSORBANCE
CONCENTRATION (mol/L)
0.87
0.75
0.43
Answer: b

4. Warm Up 2-23 Absorbance = 3. 5E-3. (Conc. ) + 0
Warm Up 2-23 Absorbance = 3.5E-3*(Conc.) Hint: Rearrange Equation
ABSORBANCE
CONCENTRATION (mol/L)
0.87
0.75
0.43
Answer: b

5. Agenda Review Design and Procedure Finish Lab Looking Ahead
Mon 2/27: Mr. Melton will be here
AP Chemistry Review Questions
WebAssign
Book Problems
Wed 3/1: End of Class - Unit 6 Quiz

6. TAKE OUT: Part A: Rate of Reaction of CV+ with NaOH SHARE: With your lab partner TIME: 3 MINUTES
Answer: b

7. Kinetics of Crystal Violet Fading
BIG IDEA:
The more color, the more concentrated, the more absorbance.
Absorbance = Concentration

8. Kinetics of Crystal Violet Fading
Guided Inquiry Design and Procedure
Part A
CV+ + OH-  CVOH
What percent of OH- ions will remain at the end of a reaction if the initial concentrations of each reactant were equal (1:1 ratio)? (1:1000)?

9. Kinetics of Crystal Violet Fading
Review: CV+ + OH-  CVOH purple colorless Rate = k[CV+]m [OH-]n

10. Kinetics of Crystal Violet Fading
Rate Law: Rate = k’ [CV+]m where k’ = k [OH-]n The constant k’ is a new “pseudo” rate constant. The new pseudo rate law is valid when the concentration of OH- ions is much greater than the concentration of CV+ ions. Under these conditions, the [OH-] term in the original rate law will not change much over the course of the reaction and may be treated as a constant in the rate equation.

11. Part B: Procedure Outline
NaOH conc. needs to be changed, not CV+, so that the effect on k’ can be calculated and the order of reaction with respect to OH- determined
Colorimeter must be zeroed with a blank, equal volumes 0.01 M NaOH and water
To make 10 mL of 0.01 M NaOH, measure 5.0 mL of M NaOH in a serological pipet and…
Clean the pipet with small portions of crystal violet solution. Measure 10 mL of 25 uM crystal violet solution…
After the absorbance vs. time data are recorded, the absorbance values need to be converted into concentration, then separate data columns for ln[CV+] and 1/[CV+] need to be created and analyzed to determine k’ for the new concentration of NaOH, M.

12. Part B: Procedure Outline
After the absorbance vs. time data are recorded, the absorbance values need to be converted into concentration, then separate data columns for ln[CV+] and 1/[CV+] need to be created and analyzed to determine k’ for the new concentration of NaOH, M.