1. Starter
Get right to work on your contour line work.

2. Art B
Air brushing

3. Agenda Go over what we did last time.
Go over the anatomy of the air brush and how to clean and care for it.
Finish our contour line art and begin spray painting.

4. Last time We had a demonstration on how to tape off your design.
Than we taped off our design.

5. Steps to using and cleaning the airbrush
How to Use an Airbrush
Steps to using and cleaning the airbrush

6. The Airbrush

7. The Airbrush

8. Mixing Paint Paint is mixed with water
The ratio is 3 drops of water to 1 drop of paint.

9. Mixing Paint Bubble the paint in the color cup.
Put your finger over the air cap to avoid any air from escaping.
Press down trigger and pull back slightly till you see bubbles in the paint cup.
This will mix the paint.

10. Painting
Hold the airbrush between the thumb and pointer finger.

11. Painting Push down the trigger and pull back to release the paint.
The closer the airbrush is to the paper the thinner the line will be and the darker your line will be.
Paint even thin layers, keeping the airbrush the same distance from the paper the entire time.

12. Cleaning the Airbrush
Run water through airbrush till spray runs clean.
Use Q tip to clean paint from inside of paint cup.

13. Cleaning the Airbrush Cleaning the air cap
Pull back the trigger so the needle is pulled back.
Using a Q tip, clean the inside of the air cap.
There should be no paint anywhere on the airbrush once it is clean.

15. What’s Next
Now that you know how to use the airbrush it’s time to use it.
Once your contour line drawing is completely taped, tape down your paper to the board in the back.
Turn on the air vent.
Paint your paper.
Clean the airbrush.