Presentation is loading. Please wait.

Presentation is loading. Please wait.

W4CQ March 2, 2019 Bill Turner, W4WNT

Similar presentations


Presentation on theme: "W4CQ March 2, 2019 Bill Turner, W4WNT"— Presentation transcript:

1 W4CQ March 2, 2019 Bill Turner, W4WNT
FT8: DX for the rest of us. W4CQ March 2, 2019 Bill Turner, W4WNT

2 WSJT-X

3 Connections Need at least one connection between radio and computer
Icom uses audio (SignaLink USB, $135) and C-IV connection in older models IC-7300 and IC-7610 use only one USB cable, $6 from Amazon Kenwoods use an audio connection (SignaLink, $135) and a Serial-USB cable (FTDI, $15 from Amazon) Kenwood TS590 uses single USB cable

4 Connections Facebook groups are very helpful in solving connection questions Software and hardware specific groups K0PIR YouTube videos

5 WSJT WSJT: Weak Signal Joe Taylor Created by Dr. Joe Taylor, K1JT
1993 Nobel Prize in Physics Discovered Dual Pulsars Applied tech to Moon Bounce

6 Operating systems WSJT and WSJT-X will run on: Windows Mac OS
Many flavors of Linux

7 WSJT Originally created for EME (Moon Bounce) in 2001.
Previously needed very high power and large antenna arrays. You needed to hear your CW signal return from the moon. 239,000 miles one way path on 2m!

8 WSJT and WSJT-X With computer algorithms, WSJT decodes the signal to the computer screen. Signal reports are given in dBs relative to the noise level. -07 is a typical report for WSJT modes. Weak Signal mode but can also be “low” power compared to other ham radio modes.

9 WSJT-X Created in 2012 to introduce other modes into WSJT. JT9, JT65 slow modes MSK144 (Meteor Scatter), FT8, and WSPR fast modes The WSJT exchanges are very structured, not a conversational mode. WSJT-X GA is the current release.

10 WSJT-X FT8 (Franke-Taylor 8) is designed for contest use on HF and VHF. Created by Steven Franke K9AN and K1JT. This new mode was introduced in July Currently the most popular WSJT mode. Was used in the International Grid Chase in 2018. A DXPedition mode WSJT-X is in use.

11 FT8 Runs in 15 second intervals, RX and TX. Formatted exchange.
Has an Auto Sequence feature. Operating frequencies are in a software table and can be edited. Timing is critical, use Dimension4 from Thinkman.com or Meinberg NTP to sync your clock for Windows OS.

12 Wide Graph (Waterfall)

13 WSJT-X screen

14 Settings-General

15 Settings - Radio

16 Audio settings in Windows Device Manager

17 WSJT-X Audio Screen

18 Other “Rigs” The Radio Screen also has Ham Radio Deluxe Omnirig
See the Instruction Manual (F1) under Section 4.2 for more info. Test CAT and Test PTT buttons on Radio Screen

19 Windows Snipping Tool Used to save screen prints.
Created the screen slides here. When you have the software running, use this tool to save the parameters that work.

20 Oops, what happened? Windows updates mess with audio settings and com ports. Save parameters. If a screw up occurs, restart the computer to ensure that the update has completed. Only then look at your software parameters for changes.

21 Wide Graph (Waterfall)

22 Wide Graph Use the widest filter setting on rig.
No DSP, Noise Reduction or Noise Blanking. Control the image with sound card/RF gain. Wide Graph also has controls to optimize the data presentation. Strongest TX output is 1500 to 2000 Hz

23

24 Main Screen dB column: received signal relative to noise level
dT column: time difference between you and the station you are decoding Time sync software keeps dT to a minimum Use time.is to check clock accuracy Windows OS needs time sync software

25 FT8 Screen Items dB measured Signal to noise ratio (S/N)
dT time offset relative to your computer clock Signals visible at -26 dB Signals audible at -15 dB 50 Hz bandwidth, 12.6 sec Tx duration 15 sec TX, 15 sec Rx

26 FT8 Frequencies 3.573, 7.074, , , 21074, , USB or USB-Data mode Power: normally low power 5-30 watts, but can use higher power (under 100watts) 2 kHz band at listed frequencies

27 Logging

28 Weak Signal Mode

29 No one needs an amp!

30 Weak Signal Mode 40w 17m 30 ft End Fed Indoor Antenna

31 One more example: 519 miles 60m 5w Indoor End Fed Antenna Danville, IL

32 Power as needed 60w 20m 9492 miles (Indoor)

33 PSK Reporter https://www.pskreporter.info/pskmap.html

34 Auto Sequence

35 Split Frequency

36 DXPedition version Released in Beta February 2018
Fox and Hound operation DXPedition = Fox, DXer = Hound Used by the Baker Island DXPedition in June and Ducie Island in Oct and the current T31EU operation Included in WSJT-X

37 Meteor Scatter Uses MSK144 on 6m and above. 15 or 30 second TX/RX
Can be done with 100w and a two element 6m beam (Moxon) Monitor Ping Jockey Central to see activity.

38 Version 2.0.1 WSJT-X v2.0.1 was released 2-25-19.
Field Day, VHF Contests, RTTY Roundup Download from Joe's Princeton.edu website Read the Quick Start doc to get more information on this newest version.

39 References WSJT Home Page:
October and November 2017 QST articles by Joe Taylor, K1JT, Steven Franke, K9AN, and Bill Somerville, G4WJS Time Sync software: Dimension4: Thinkman.com Meinberg:

40 Additional Resources IGC Grid Map:
Antenna: PSK Reporter: Ping Jockey Central (Meteor Scatter):

41 References Facebook: FT8 Digital Mode Experimental (and General Use) Group Yahoo: WSJT Group Ian Wade: G3NRW.net/IC-7300 also has a TS590 family website Gary Hinson, ZL2IFB

42 References You Tube: Work the world with WSJT-X by Dr. Joe Taylor
You Tube: FT8 Description, Myths and Operation (N2ADV) Questions?


Download ppt "W4CQ March 2, 2019 Bill Turner, W4WNT"

Similar presentations


Ads by Google