1. Macpi 334, electrical + steam heated
132°C set
44.000
35 min.
Electrical Consumption
14.000
06:35
Time
Steam Pressure bar
Steam Temp °C
Consumpt Kg
Floor Temp. °C
Temp Top Heater °C
Temp Bottom Heater
Front, °C
Back, °C
05:50
5,5
161  - 24 23
Warm up with steam
06:20
101 39
06:30
9,64
118 99
113
06:35
Electrical power on
07:10
12,5 26
132
30 min. of machine use
07:30
5,2
160
13,5 28
133
07:40
14,5
Average
4,0 kg/h
Steam Consumption
80 min
35 min
Total consumption:
Average electrical power 14 kW/h +
Average steam consumption 4,0 kg/h

2. Macpi 334, electrical + steam heated versa DXT 1600
44.000
132°C, 15 sec.
Macpi 334, 1600
14 kW/h + 4 kg steam/h
14.000
46.000
132°C, 15 sec.
DXT 1600
14 kW/h
13.500

3. Macpi 334, electrical + steam heated
Surface Temperatures
Set Temperature
132 °C, 15 sec.
Macpi 334
90°C
62°C
43°C
39°C
52°C
EX- FE
24°C
48 °C
35 °C
34 °C
33 °C

4. Macpi 334, electrical + steam heated
Some impressions from a machine less than 0,5 year old.
Insolation of the steam- and electrical elements.
Not very sufficient and look like not very professional.
The wiring is very confusing, which cable belongs to which heating element ?
All bearings are not sealed and need constantly maintenance.
Dust and dirt will accumulate on the grease and after some while will lead to some sluggishness.
Even worst, when greasing is not done correctly, grease comes off the bearings everywhere and will soil other parts of the machine.
On the machine shown grease was leaving the bearings towards the pressure rollers.