Download presentation
Presentation is loading. Please wait.
1
Schematic to Pictorial
G7a Schematic to Pictorial
2
You will now draw the Pictorial by following the Schematic
3
The process will be to follow the schematic one wire at a time from one component to another component until you are finished.
4
The slides that follow will show the wire in RED on the schematic that is going to be wired on the pictorial. Then the pictorial slide will show that wire being ‘installed.’ This is the wire you are to place on your pictorial. Keep advancing through this slide presentation until you are finished with the pictorial.
5
Let’s start with the 240v LINE VOLTAGE circuit.
6
This page has the whole circuit shown
This page has the whole circuit shown. But let’s move onto the next screen where there will be a ‘closer’ view of the 240v circuit.
8
You should now follow the schematic one wire at a time from one component to another component until you are finished. Please use the diagram on page G7a.
9
As you click through each slide, you will see the red wire on the schematic that you are to then complete on the pictorial.
25
NOTE: There is no O.L. shown
on the schematic, but on this pictorial there is, so the O.L. is connected in series with the ‘C’ terminal of the compressor.
36
You have finished the 240v LINE VOLTAGE circuit.
37
The next slide shows your completed PICTORIAL and this is what you need to show your Instructor for credit.
39
THE END
Similar presentations
© 2024 SlidePlayer.com Inc.
All rights reserved.