1. Dive Mishap Reporting Afloat Safety Division Code 32 Diving
(757) x 7837

2. WESS Landing Page
Select Mishap/Hazard Reporting

3. Select Shore/Ground and hover your cursor over Mishap Reporting. A
new mishap type box will appear and select diving.

4. Click on select under General Information

5. Select Diving (on duty) and Continue

6. Enter all pertinent information, for each one of the pages listed
in blue.

7. List any authorized drafters and be sure to select All Navy
Authorized drafters can be anyone from your Chain of Command (i.e. Diving Officer, Master Diver, Diving Supervisor, Safety Officer who has data entry permissions) or any personnel from your ISIC who may have a need to review or enter data to complete the report.
List any authorized drafters and be sure to select All Navy
Diving Commands under Community of Interest (COI)

8. List any involved commands, to add an involved command, click add command
and fill out all applicable information. Any command listed as involved will be
able to see the full version of the report.

9. Fill out applicable involved property information
Fill out applicable involved property information. Start typing noun name
in EIC block and most likely choices will show up. To add more than one involved
property, click add property under Involved Property drop down.

10. Fill out all Involved Personnel information
Fill out all Involved Personnel information. To add additional personnel
Click “add” person under Involved Personnel drop down.

11. When filling in preconditions, supervisory, and organizational factors, select
factors which best fit the scenario, then click the blue “add” radio button.

12. Fill in applicable recommendation information. If there are multiple
recommendations, select which factor they apply to. To add additional
recommendations, click “recommendations” drop down. Once completed,
click on “save”, then select “validate”.

13. After selecting “validate”, if there are any corrections they will be annotated
in red next to the corresponding page that the correction is needed on. The
number indicates how many corrections are needed per page.

14. Once validated click save
Once validated click save. At this point, click “Report Actions”, “View PDF,
and save a copy for your files.

15. After saving a copy of the PDF for your files, Click on “Release” to send
the report to the Naval Safety Center.