1. Lecture 5 Introduction to Hypothesis tests
Quantitative Methods Module I
Gwilym Pryce
Lecture 5 Introduction to Hypothesis tests

2. Notices:
Register
Class Reps and Staff Student committee.

3. Aims & Objectives Aim Objectives To introduce hypothesis testing
By the end of this session, students should be able to:
Understand the 4 steps of hypothesis testing
Run hypothesis test on a mean from a large sample;
Run hypothesis test on a mean from a small sample;

4. Plan: 1. Statistical Significance
2. The four steps of hypothesis testing
3. Hypotheses about the population mean
3.1 when you have large samples
3.2 when you have small samples

5. 1. Significance
Does not refer to importance but to “real differences in fact” between our observed sample mean and our assumption about the population mean
P = significance level = chances of our observed sample mean occurring given that our assumption about the population (denoted by “H0”) is true.
So if we find that this probability is small, it might lead us to question our assumption about the population mean.

6. I.e. if our sample mean is a long way from our assumed population mean then it is:
either a freak sample
or our assumption about the population mean is wrong.
If we draw the conclusion that it is our assumption re m that is wrong and reject H0 then we have to bear in mind that there is a chance that H0 was in fact true.
In other words, when P = 0.05 every twenty times we reject H0, then on one of those occasions we would have rejected H0 when it was in fact true.

7. Obviously, as the sample mean moves further away from our assumption (H0) about the population mean, we have stronger evidence that H0 is false.
If P is very small, say 0.001, then there is only 1 chance in a thousand of our observed sample mean occurring if H0 is true.
This also means that if we reject H0 when P = 0.001, then there is only one in a thousand chance that we have made a mistake (I.e. that we have been guilty of a “Type I error”)

8. There is a tradition (initiated by English scientist R. A
There is a tradition (initiated by English scientist R. A. Fisher ) of rejecting H0 if the probability of incorrectly rejecting it is  0.05.
If P  0.05 then we say that H0 can be rejected at the 5% significance level.
If P > 0.05, then, argued Fisher, the chances of incorrectly rejecting H0 are too high to allow us to do so.
the probability of a sample mean at least as extreme as our observed value occurring, will be determined not just by the difference between our assumed value of m, but also by the standard deviation of the distribution and the size of our sample.

9. Type I and Type II errors:
P = significance level = chances of incorrectly rejecting H0 when it is in fact true.
Called a “Type I error”
So sig = Pr(Type I error) = Pr(false rejection)
If we accept H0 when in fact the alternative hypothesis is true
Called a “Type II error”.
On this course we shall be concerned only with Type I errors.

10. 2. The four steps of hypothesis testing
Last week we looked at confidence intervals:
establish the range of values of the population mean for a given level of confidence
e.g. we are 90% confident that population mean age of HoHs in repossessed dwellings in the Great Depression lay between and years (s = 20).
Based on a sample of 200 with mean = 34.5yrs.
But what if we want to use our sample to test a specific hypothesis we may have about the population mean?
E.g. does m = 30 years?
If m does = 30 years, then how likely are we to select a sample with a mean as extreme as 34.5 years?
I.e. 4.5 years more or 4.5 years less than the pop mean?

12. One tailed test: P = how likely we are to select a sample with mean age at least as great as 34.5?

13. How do we find the proportion of sample means greater than 34.5?
Because all sampling distributions for the mean (assuming large n) are normal, we can convert points on them to the standard normal curve
e.g. for 34.5:
z = ( )/(20/200)
= 4.5 / 1.4
= 3.2

16. Upper tailed test:

17. Two tailed test:

18. 3. Steps to Hypothesis tests:
1. Specify null and alternative hypotheses and say whether it’s a two, lower, or upper tailed test.
2. Specify threshold significance level a and appropriate test statistic formula
3. Specify decision rule (reject H0 if P < a)
4. Compute P and state conclusion.

19. P values for one and two tailed tests:
Use diagrams to explain how we know the following are true:
Upper Tail Test: population mean > specified value
H1: m > m0 then P = Prob(z > zi)
Lower Tail Test: population mean < specified value
H1: m < m0 then P = Prob(z < zi)
Two Tail Test: population mean  specified value
H1: m  m0 then P = 2xProb(z > |zi|)

22. Test the hypothesis that the average man in the population is obese.
E.g. The obesity threshold for men of a particular height is defined as weighing over 187lbs; mean weight of men in your sample with this height is lbs, sd = 13.7lbs, n = 94. Are the men in your sample typically obese?
Test the hypothesis that the average man in the population is obese.
How do we write Step 1?
Because H1: m > m0 then P = Prob(z > zi)
So this is an Upper tailed test & we write:
H0: m = 187lbs
H1: m > 187lbs

23. How do we write Step 2? (a and appropriate test statistic formula)
Large sample

24. How do we write Step 3?

25. How do we write Step 4?

26. The upper tail significance level is given by SIGZ_UTL = 0.00663
What can we conclude from this?

27. eg Test the hypothesis that male super heroes/villains tend to be c
eg Test the hypothesis that male super heroes/villains tend to be c. six foot tall.
1st you need to convert scale: 6ft = cm
2nd you need to run descriptive stats on height to get the n, x-bar, and s:
n = 29
xbar = cm
s = 8.701

28. H_L1M n=(29) x_bar=(181.72) m=(182.88) s=(8.701).
Compare this output with that of the large sample 95% confidence interval & interpret:

29. Hypotheses about the population mean when you have small samples
This is exactly the same as the large sample case, except that one uses the t-distribution provided that x is normally distributed.
Many statisticians use t rather than z even when the sample size is large since:
(i) strictly speaking our approximation for the SE of the mean has a t rather than z distribution
(ii) t tends towards the z distribution when n is large

30. How do the results differ, if at all?
E.g. re-run the hypothesis test on height of super heroes using a t test: H_S1M n=(29) x_bar=(181.72) m=(182.88) s=(8.701).
How do the results differ, if at all?
N.B. the t-distribution tends to have fatter tails – smaller the sample, fatter the tails become.

31. Reading & Exercises: Confidence Intervals: Tests of Significance:
M&M section 6.1 and exercises for 6.1 (odd numbers have answers at the back)
Tests of Significance:
M&M section 6.2 and exercises for 6.2
Use and Abuse of Tests:
M&M section 6.3 and exercises for 6.3
*Power and inference as a Decision
Type I & II errors etc.
*optional