1. SUPPORT FRAME ASSEMBLIES, 4 REQUIRED
48”
“MEND PLATE” BOTH SIDES
(24 REQUIRED)
45°
26”
FORWARD LEG – ATTACH WITH 3 OF #8 X 2.5” DRYWALL SCREW
12 ½”
30”
MAKE FROM NOMINAL 2X4 STOCK (1.5X3.5)

2. 8”
48”
PLYWOOD SHEET CUT LAYOUT. LAST STRIP WILL BE NARROW BY CUMULATIVE WIDTH OF SAW KERF.

3. ~12 ½”
8” x 48”
8” x 96”
SUPPORT STRIPS – 1 SHEET OF 4’X8’ 3/8” CHIP BOARD
RIP INTO 6 STRIPS OF 8” WIDE,
CUT 2 STRIPS TO 48” LONG
LAY OUT STRIPS AS SHOWN TO FORM 12’ WIDE SUPPORT FRAME
ATTACH WITH 2 OF #6 X 1 5/8 DRYWALL SCREW AT EACH FRAME CROSSING.