1. Cal DQM Report
July 7 – July 14, 2004

2. July 8th Updated bad channel list using CAL quick-calib 50632
Created version 3653 with 357 bad channels, 0 holes.
6 bad FEC’s, 3 bad ADC’s

3. B5 UNO

4. July 9th Updated bad channels using CAL quick-calib 50644
Version 3654 created with 361 b.c’s and 0 holes
Same bad FEC’s & ADC’s
Checkout runs done:
QINJ 18361
UNO 18362
PED 18363
LASER 18364
LED 18365
Created version 3654 by mistake-didn’t use it

5. July 9th (cont.) Full Electronic Calibration
CALIB version b.c’s, 0 holes
Trimming:
UNO (0) 121(0) 29(0)
UNO (0) 116(0) 27(0)
Created version 3657 with 302 b.c’s and 0 holes
3 FEC’s and 2 ADC’s

6. July 10 Updated bad channel list with CAL quick-calib 50661
Created version b.c’s 0 holes

7. July 11 Updated bad channel list with CAL quick-calib 50677
Created version b.c’s 0 holes
Called by ZCR at 10:30, the hip presenter shows 12 new b.c’s for QINJ during run 50684
Compare QINJ for and online QINJ histos, bad channels in R5. I told the ZRC to take a CAL quick-calib, and that I would use it to update the b.c’s

8. Comparison of R5 for 2 runs

9. July 12 Updated bad channel list using CAL quick-calib 50687
Unfortunately R5 is not bad anymore…
Created version 3660 with 321 b.c’s and 0 holes
ZCR calls-1 hour break
Run auto_adc2volt.sh
Creates adc2volt version 2381, cal verison 3662, with 295 b.c’s, 0 holes

10. R5 revisited, problem gone

11. July 12 (cont.) Did checkout runs QINJ 18390 UNO 18391 PED 18392
LASER 18393
LED 18394

12. July 13
Updated b.c’s using CAL quick-calib 50698, version 3663: 303 b.c’s, 0 holes (done the previous night)
Took checkout runs
QINJ 18395
UNO 18396
PED 18397
LASER 18398
LED 18399
Break in morning but no call from ZCR, instead they did a CAL quick-calib, so I used it to update the b.c’s, version 3664: 306 b.c’s, 0 holes.

13. Problems
No calls from ZCR! (Except for the R5 thing)

14. DQM
Checked all runs taken during the week, all seemed fine, some weird thing in the pull for BCAL.