2. Functionality Calibrates Bump Tests Charges Prints certificates
2-button operation

3. Standard Configurations
M40 only version
M40/SP40 pump version
6 unit versions
All configurations

4. Calibrations Initiated by pushing and holding CAL button
Approximately 2 minutes
Real time readings on M40 Display
Pass/Fail LED
Cal certificate automatically generated
Stores up to 150 records before over-write

5. Bump Tests Initiated by pushing BUMP button
Performs a true “Found As” test
90 seconds of gas, 85% of span reading
Pass/fail (LED)
Bump certificate automatically generated

6. Calibration/Bump Certificates
Generated after each bump or calibration
Stored in onboard non-volatile memory
Contains serial number, time, date, sensor information, pass/fail, span values, bump values (for bump tests).

7. Optional Printer Automatically prints reports Serial interface
Bump reports
Calibration reports
Prints memory

8. Six unit versions Available in any configuration
Calibrates one “deck” at a time
One calibration per connect

9. M40 Support Software version 4.0 and higher
A hardware upgrade is required
Service will be offering an upgrade service - $125.00

10. Pricing and Availability
Single unit versions – September 1
Six unit versions – October
Single unit = $795.00
Six unit = $
Kits available October