Presentation is loading. Please wait.

Presentation is loading. Please wait.

Test Setup TPS1H100 EVM Supply voltage VS = 13.5V Electronic load

Published byDominick Stanley Hancock Modified over 5 years ago

Similar presentations

Presentation on theme: "Test Setup TPS1H100 EVM Supply voltage VS = 13.5V Electronic load"— Presentation transcript:

1 Test Setup TPS1H100 EVM Supply voltage VS = 13.5V Electronic load
The current limit has an overshoot of around 35% higher than the limit set. The CS has a settling time of around 150uS but not deglitch time. If the output voltage decay slowly the CS signal has smooth transition. If the output voltage has fast transition the CS signal has fast transition and 150uS settling time

2 Current limit 2A and over current of 2
Current limit 2A and over current of 2.1A The output voltage decay slowly

3 Current limit 2A and over current of 10A The output voltage decay is very fast

Download ppt "Test Setup TPS1H100 EVM Supply voltage VS = 13.5V Electronic load"

Similar presentations

Selected Design Topics. Integrated Circuits Integrated circuit (informally, a chip) is a semiconductor crystal (most often silicon) containing the electronic.

Selected Design Topics. Integrated Circuits Integrated circuit (informally, a chip) is a semiconductor crystal (most often silicon) containing the electronic.
Operational Amplifiers

Operational Amplifiers
Electronic memory & logic devices. Solid State Physics N N P P +- Transistors And diodes Logic gates Memory devices : Flip flops Flip Flop Flip Flop Flip.

Electronic memory & logic devices. Solid State Physics N N P P +- Transistors And diodes Logic gates Memory devices : Flip flops Flip Flop Flip Flop Flip.
Precision AC Current Measurement Technique Guildline Instruments Limited.

Precision AC Current Measurement Technique Guildline Instruments Limited.
7.2 The Basic Gain Cell 7.3 The Cascode Amplifier

7.2 The Basic Gain Cell 7.3 The Cascode Amplifier
Switching Power Supply Component Selection

Switching Power Supply Component Selection
ECE 4951 Lecture 5: PID Control of Processes. PID Control A closed loop (feedback) control system, generally with Single Input-Single Output (SISO) A.

ECE 4951 Lecture 5: PID Control of Processes. PID Control A closed loop (feedback) control system, generally with Single Input-Single Output (SISO) A.
ECE 442 Power Electronics1 Full-Wave Bridge Rectifier.

ECE 442 Power Electronics1 Full-Wave Bridge Rectifier.
ECE 442 Power Electronics1 Full-Wave Rectifier with RL Load.

ECE 442 Power Electronics1 Full-Wave Rectifier with RL Load.
SUB; ANALOG ELECTRONICS PREPARED BY MR.HUTESH BAVISKAR.

SUB; ANALOG ELECTRONICS PREPARED BY MR.HUTESH BAVISKAR.
Source Transformation

Source Transformation
Digital to Analog Converters

Digital to Analog Converters
1 Electronic Circuits COMMON EMITTER CIRCUITS. 2 Electronic Circuits AMPLIFIERS CAN BE CLASSIFIED AS EITHER: VOLTAGE AMPS POWER AMPS AMPLIFIERS CAN BE.

1 Electronic Circuits COMMON EMITTER CIRCUITS. 2 Electronic Circuits AMPLIFIERS CAN BE CLASSIFIED AS EITHER: VOLTAGE AMPS POWER AMPS AMPLIFIERS CAN BE.
Low power CDN. SPEED Operate vdd at half rails Data should operate at full rails.

Low power CDN. SPEED Operate vdd at half rails Data should operate at full rails.
Delivering MORE Together What is SuPA?. SuPA: Supply for Power Amplifier “SuPA” = DC/DC converter that provides an adaptive, optimized output power supply.

Delivering MORE Together What is SuPA?. SuPA: Supply for Power Amplifier “SuPA” = DC/DC converter that provides an adaptive, optimized output power supply.
9/27/2004EE 42 fall 2004 lecture 121 Lecture #12 Circuit models for Diodes, Power supplies Reading: Malvino chapter 3, 4.1-4.4 Next: 4.10, 5.1, 5.8 Then.

9/27/2004EE 42 fall 2004 lecture 121 Lecture #12 Circuit models for Diodes, Power supplies Reading: Malvino chapter 3, Next: 4.10, 5.1, 5.8 Then.
Dc regulated power supply SKN. Introduction All electronic circuits need DC power supply either from battery or power pack units. Many electronic equipment.

Dc regulated power supply SKN. Introduction All electronic circuits need DC power supply either from battery or power pack units. Many electronic equipment.
4.2.3B Electrical Power What About Watts?. Power Law Moving electrons (current) requires ENERGY How much energy gets used depends on: Strength of push.

4.2.3B Electrical Power What About Watts?. Power Law Moving electrons (current) requires ENERGY How much energy gets used depends on: Strength of push.
Rectification. AC to DC Electricity distribution –Power stations –Transformers –Transmission lines AC Electronics DC –Smooth –Stable.

Rectification. AC to DC Electricity distribution –Power stations –Transformers –Transmission lines AC Electronics DC –Smooth –Stable.
Tutorial: Mechanic - electrician Topic: Electronics II. Class Operational Amplifiers: Comparators – Part 1 - Basics Prepared by: Ing. Jaroslav Bernkopf.

Tutorial: Mechanic - electrician Topic: Electronics II. Class Operational Amplifiers: Comparators – Part 1 - Basics Prepared by: Ing. Jaroslav Bernkopf.

Similar presentations

Ads by Google