1. Agenda item 8b WISE SoE reporting 2015 state of the play
When: The reporting will take place from 1st December 2015 until 29 February 2016
What: 2013 and 2014 data on water quality (in rivers, lakes, groundwater), emissions to water and water quantity
Data from previous years (update or additional) as it was indicated as being available in the quality fact sheets
Test phase: will be open from 2nd November until 30 November.
Any problems occurring during the testing should be communicated via
Olaf Büttner (ETC), Fernanda Néry (EEA)
WG DIS, Brussels, 13/14th October 2015

2. Water Quality (WISE-4)
Data dictionary:
Structure simplified (16 tables to 5 tables)
Reporting of disaggregated data is possible for nutrients and hazardous substances
Common code list of parameters, used also in WISE SoE Emissions and WFD
Spatial unit identifiers (monitoring sites and water bodies) harmonized with WFD
Spatial data reported via the WISE spatial reference data flow
Olaf Büttner (ETC), Fernanda Néry (EEA)
WG DIS, Brussels, 13/14th October 2015

3. Water Quantity (WISE-3)
Data dictionary: (final draft, open for comments until 15th of October)
Implemented as a standard reporting flow via Reportnet. No longer requires a specific reporting software tool
Complete revised data model with
Simplified structure with 7 tables
Harmonization of parameters with EUROSTAT and WFD
Significant reduction in the number of parameters:
127 parameters removed from the Water Quantity reporting;
74 parameters requested (of which 13 newly introduced).
Spatial data reported via the WISE spatial reference data flow
Olaf Büttner (ETC), Fernanda Néry (EEA)
WG DIS, Brussels, 13/14th October 2015

4. Emissions (WISE-1)
Data dictionary:
Simplified data model (1 table instead of 4 tables) containing emissions from point and diffuse sources
Common code list of substances, used also in WISE SoE Water Quality and WFD
WISE SoE source categories harmonised with WFD Pressures (next slide)
Spatial data will be reported via the WISE spatial reference data flow
since the changes will be introduced in version on the WFD schemas (i.e. past the deadline for 6.0.1, which was published today), it should be presented next week on the DIS meeting. So put it in the Emissions slide – no big text – just a table and an explanation about the alignment and then mention (no need to write) that the WFD code list will be updating accordingly.
Olaf Büttner, Fernanda Nery (EEA)
WG DIS, Brussels, 13./14th October 2015

5. WISE SoE Emissions source
Emissions to water
WISE SoE source categories aligned with WFD Pressures
WFD Pressure
WISE SoE Emissions source
Comment
1 – Point source of pollution
PT – Point sources
Note that the proper correspondence is PT plus NP5.
1.1 – Point - Urban waste water 
U – Point - Urban waste water
Further disaggregation is possible in the WISE SoE Emissions data flow.
1.2 – Point - Storm overflows
NP5 – Diffuse - Storm overflow emissions
Note that in the WISE SoE Emissions data flow, this source is reported as a diffuse sources.
1.3 – Point - IED plants
I – Point - Industrial waste water
1.4 – Point - Non IED plants
1.5 – Point - Contaminated sites or abandoned industrial sites
O1 – Point - Contaminated sites or abandoned industrial sites
Note that under WISE SoE Emissions, these emissions can be included in the "O – Point - Other" value if the data is not disaggregated by subcategory.
1.6 – Point - Waste disposal sites
O2 – Point - Waste disposal sites
1.7 – Point - Mine waters
O3 – Point - Mine waters
1.8 – Point - Aquaculture
O4 – Point - Aquaculture
1.9 – Point - Other
O – Point - Other
Note that further disaggregation is possible under the WISE SoE Emissions data flow. A direct matching to WFD 1.9 only exist if subcategories O1, O2, O3 and O4 are reported, and if only the remainder sources are reported under the generic category "O – Point - Other".
2 – Diffuse source of pollution
NP – Diffuse sources
Partial correspondence. Note that WFD 2.5 is included under point sources in the WISE SoE Emissions.
2.1 – Diffuse - Urban run-off
NP4 – Diffuse - Urban run-off
2.2 – Diffuse - Agricultural
NP1 – Diffuse - Agricultural emissions
2.3 – Diffuse - Forestry
NP71 – Diffuse - Forestry emissions
2.4 – Diffuse - Transport
NP72 – Diffuse - Transport emissions
2.5 – Diffuse - Contaminated sites or abandoned industrial sites
No direct correspondence with WISE SoE Emissions sources. This type of emissions are reported under "O1 – Point - Contaminated sites or abandoned industrial sites" (or, if disaggregated values are not available, under "O – Point - Other").
2.6 – Diffuse - Discharges not connected to sewerage network
NP3 – Diffuse - Un-connected dwellings emissions
2.8 – Diffuse - Mining
NP73 – Diffuse - Mining emissions
2.7 – Diffuse - Atmospheric deposition 
NP2 – Diffuse - Atmospheric deposition
2.9 – Diffuse - Aquaculture
NP74 – Diffuse - Aquaculture emissions
2.10 – Diffuse - Other
NP7 – Diffuse - Other diffuse emissions
Partial correspondence: NP7-(NP71+NP72+NP73+NP74)+NP8
No correspondence
NP8 – Diffuse - Background emissions
since the changes will be introduced in version on the WFD schemas (i.e. past the deadline for 6.0.1, which was published today), it should be presented next week on the DIS meeting. So put it in the Emissions slide – no big text – just a table and an explanation about the alignment and then mention (no need to write) that the WFD code list will be updating accordingly.

6. WISE - Spatial Data (WISE-5)
Spatial data must be reported according to WISE GIS Guidance 6.0.1
Spatial data only have to be reported once
All spatial references in any of the WISE SoE reporting tables will be checked against reported spatial data
Reporting format is GML ( online conversion from shapefile to GML is available )
A test phase will be open
First reporting in WISE SoE is open from 1st December 2015 until 22 March 2016
In future: reporting of new or update of spatial data (e.g. monitoring sites) will be possible the whole year
Olaf Büttner, Fernanda Nery (EEA)
WG DIS, Brussels, 13./14th October 2015