2. The engine block heater of your car are used to reduce the stress on your engine during the cold weather.

3. The heater warms up the oil or coolant of the engine and makes them much easier to start a cold engine. It can improve the fuel economy in winter.

4. Thus, the electric heaters of your car allows the engine to reach their desired temperature much more quickly.

5. Several kinds of engine heater are available in the market, that will depend on the make and model of the car and its mechanical abilities.

6. Here consider the installation procedures of engine block heater to start your car in cold weather.

8. The warm engine of your car make it slightly easier to remove the drain plugs if they are made from different metals than the engine block.

9. If you want to handle a cold car then it will protect you from burning. So, choose the one that you are comfortable with.

10. So select the one that meets your needs and compatible with the car. Then jack up the front end of the car and remove the plastic engine covers.

12. You can refer your owner's manual for getting the specific instructions about the equipment required for installing the engine block heater.

13. Remove the clips that can hold the radiator cover and the bolts that can hold the radiator mounting bracket.

14. Slide a pan under the engine and pull out the specified drain plug at the end of the engine block. Then remove the radiator cap to accelerate drainage.

16. Pre-fit the connections between the heating rods and the power cords. Then drop the male end of the cord into the engine department.

18. If the trapped air is present resistance, then displace it with more grease. Thus, the metal clip should be facing the rear of the car.

20. At last plug the cord into the rod, then run the wire harness through the engine compartments just out of the front grill.

21. Don't move the car parts or the hoses and follow the included direction for improvising the installation process.

22. Once you place the cord in the correct position, secure it with wire ties. To keep the cord of the engine manifold doesn't leave the slack behind the first tie.

24. By following the above-mentioned points, you can easily install the engine block heater of your car.

25. Now you have a car that will provide more fuel efficient in cold weathers.

26. THANK YOU! https://sbautowerks.com/ https://twitter.com/hashtag/SantaBarbaraAuto Repair?src=hash https://www.facebook.com/Santa-Barbara- Autowerks-Inc-455768191174331/ https://www.instagram.com/sbautowerks /