1. If you can Pass Your Cisco 200-401 Exam in First Attempt https://www.dumps4download.co.in/free-200-401-practice-questions.html

2. THEN PREPARE YOUR 200-401 EXAM WITH OUR WEBSITE For more info visit this: https://www.dumps4download.co.in/free-200-401-practice-questions.html

3. Introduction Of 200-401 Exam Managing Industrial Networks with Cisco Networking Technologies https://www.dumps4download.co.in/free-200-401-practice-questions.html

4. ABOUT EXAM : Exam Number : 200-401 IMINS Associated Certifications :Cisco Industrial Networking Specialist Duration : 75 minutes (55 - 65 questions) Available Languages : English, Japanese Register : Pearson VUE Exam Policies :Read current policies and requirements Exam Tutorial : Review type of exam questions https://www.dumps4download.co.in/free-200-401-practice-questions.html

5. DESCRIPTION: This exam tests a candidate's knowledge of the OSI layers of IP networks, as well as networking devices like routers and switches, and cabling approaches; specific industrial devices such as drives, PLCs, sensors, and substation equipment; relevant industrial standards and models such as TIA, the Purdue model, and environmental standards; and various safety protocols important in an industrial zone. Candidates can prepare for this exam by taking the Managing Industrial Networks with Cisco Networking Technologies course. RECOMMEND TRAINING: The following courses are recommended training for this exam. Managing Industrial Networks with Cisco Networking Technologies Networking Fundamentals for Industrial Control Systems (INICS) Control Systems Fundamentals for Industrial Networking (ICINS) Courses listed are offered by Cisco Learning Partners-the only authorized source for Cisco IT training delivered exclusively by Certified Cisco Instructors. Check the List of Learning Partners for a Cisco Learning Partner nearest you

6. What are two benefits of a star network topology? (Choose two.) A. Disruption of the entire network is not required when adding new machines. B. Any problem which leaves the network inoperable can be traced to the central hub. C. This network type requires less cable as compared to linear bus topology. D. The performance of one of the numerous nodes cannot reflect on the performance of other nodes. E. The performance of the entire network is directly dependent on the performance of the hub. Answer: A,B DEMO QUESTION NO :01 https://www.dumps4download.co.in/free-200-401-practice-questions.html

7. Which prompt is used to configure parameters for the Ethernet ports of an industrial switch? A. Switch(config-if)# B. Switch(config-if-ind)# C. Switch(config-line)# D. Switch(config-ind)# E. Switch(config-vlan)# Answer: A DEMO QUESTION NO :02 https://www.dumps4download.co.in/free-200-401-practice-questions.html

8. EtherNet/IP is an Ethernet implementation of which protocol? A. CIP B. Industrial Protocol C. DeviceNet D. ControlNet Answer: A DEMO QUESTION NO :03 https://www.dumps4download.co.in/free-200-401-practice-questions.html

9. Given a ring topology, which loop prevention mechanism provides the fastest reconvergence time after a link failure? A. Rapid Per-VLAN Spanning Tree Protocol B. Resilient Ethernet Protocol C. Multiple Spanning Tree Protocol D. Spanning Tree Protocol Answer: B DEMO QUESTION NO :04 https://www.dumps4download.co.in/free-200-401-practice-questions.html

10. Which characteristic causes multimode fiber-optic cable to differ from single mode? A. by allowing multiple network services in the same cable B. shorter maximum network segment length for a given bandwidth C. a wider variety of available connector types D. use outdoors as well as indoors Answer: B DEMO QUESTION NO :05 https://www.dumps4download.co.in/free-200-401-practice-questions.html

11. Managing Industrial Networks with Cisco Networking Technologies https://www.dumps4download.co.in/free-200-401-practice-questions.html