1. ProJet 3000/3500 Training
Daily Agenda

2. Day 1 8:30 AM: Meet at 3D Systems 8:30- 9:00: Welcome and Introduction
9:00- 9:15: Tour 3D Systems
9:15-10:00: Safety and Material Hazard
10:00-10:30: Removing and Replacing Side Panels
10:30-10:45: Break
10:45-11:15: General Introduction of main assemblies
11:15- 12:00: Drop Mass Tests and Tag Tests
12:00- 1:00: Lunch
1:00- 2:30: X Motion System
2:30- 3:30: Printhead Introduction
3:30- 4:30: Planerizer Introduction
4:30- 5:00: Client Software
5:00: Dismissal 2 4 2

3. Day 2 8:30 AM: Meet at 3D Systems
8:30- 10:30: Begin Installation Process
10:30-10:45: Break
10:45-12:00: Installation Process
12:00- 1:00: Lunch
1:00- 4:30: Installation Process
4:30- 5:00: Question and Answer
5:00: Dismissal 3 4 3

4. Day 3 8:30 AM: Meet at 3D Systems 8:30- 10:30: Installation Process
10:30-10:45: Break
10:45-12:00: Planerizer wiper replacement
12:00- 1:00: Lunch
1:00- 3:00: UV Bulb replacement
3:00- 5:00: Material Feed System Removal and Replacement
5:00: Dismissal 4 4 4

5. Day 4 8:30 AM: Meet at 3D Systems
8:30- 10:30: Printhead Recovery Procedures
10:30-10:45: Break
10:45-12:00: Z Motion, X Motion and Waste System
12:00- 1:00: Lunch
1:00- 5:00: RMT DIAGS
5:00: Dismissal 5 4 5

6. Day 5 8:30 AM: Meet at 3D Systems 8:30- 9:00: Grade and Review Tests
9:00-10:30: Troubleshooting Test
10:30-10:45: Break
10:45-1:00: Error logs and troubleshooting tips
1:00: Dismissal or Remedial Classroom time 6 4 6